Search: demco ez latch coupler   >  

Yes, the correct replacement door latch kit you'd want is the Global Link RV Entry Door Locking Latch Kit with Keyed Alike Option #295-000019. This matches the exact type of latch that you sent in a picture of. I attached a review video for…

I was able to go out to our warehouse and measure the face plate on the Bauer Products Camper Door Lock #BA65FR. The face plate is 5-1/2" tall and 5-7/8" wide.

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and…

There is! To replace the standard pin and clip on the Curt QuickPin No Latch A-Frame Trailer Coupler #C84DR Curt actually recommend the Hitch Lock #C23025 which is what I recommend going with!

There typically aren't any part numbers stamped onto the trailer spindle that can be used for identification. There are however numbers stamped onto the hub most times which can be used for identification. The TDE46210 tells me you have a…

We have just what you are looking for. I called my contact at TDE and asked about the hub you have on your boat trailer. They told me that it was a 5-stud idler hub for a 3,500-lb axle. That means you need the part #AKIHUB-545-35-K. This is a fit for…

To install the Demco A-Frame Trailer Coupler #DM16680-52 that you referenced, you will want to use 3/8 inch, grade 5 bolts , approximately 1-1/2 inches long (depending on how you are installing the coupler). You will want to use 5 of these bolts per…

The Demco coupler #DM16680-52 you were looking at does not include the hardware needed for installation. It would be a good idea to switch over from your weld on to a bolt on coupler, this will make it a whole lot easier to replace over time as it…

The eZ latch of the Demco 50-Degree A-Frame Trailer Coupler w/ Jack Hole and Anchors, eZ-Latch - 2-5/16" Ball - 21K #DM16680-52 is absolutely just as safe as a slide lock coupler. It doesn't use a pin but still exceeds the SAE J684 safety…

The Demco eZ latch style of couplers like the #DM16680-52 do have adjustability of the tongue mechanism that holds to the hitch ball.

If you look at the diagram that I received from my contact at Demco, you can see several of the dimensions of the #DM14793-81 trailer coupler. If there were other dimensions you were needing, please let me know.

I checked the Featherlite Trailer website for specs on the model 3116 trailer but this part number returned no results. But if your trailer uses an industry-standard 50-degree a-frame design then the Demco A-Frame Trailer Coupler #DM16680-52 will fit…