Search: gas shock   >  

The typical springs for the AL-KO 4,400 axles are one of two lengths. If you have the 25-1/4 inch length, then you will want the 4-Leaf Double-Eye Spring for 5,000-lb Trailer Axles #e28SR, but if you have the 26 inch springs, you will want the…

A 4-terminal starter solenoid like the Pollak #PK5230701 needs to be wired so that the 12V power in/out is connected to the two larger terminals while the two smaller terminals are connected to ground and an ignition source. A 3-terminal solenoid…

The left and right ramps springs #RS16933LH and #RS16933RH install on a shaft of 1-1/2-inches diameter. The width of the coil is 2-1/2-inches and the overall length of each spring is 11-inches. You can refer to the linked videos and to the linked…

I think I have a solution to your ride issue on your 2015 Dodge Durango. Unfortunately, looking a the measurements of the pictures that you sent you will not have enough room to install a weight distribution system on the tongue of your trailer…

Since you came from a Dexter Actuator I can help you troubleshoot the problem. If you do not have a Dexter unit let me know and I will be glad to see if I can help you out. Most issues are related to wiring or ground problems. Since it sounds like…

The CE Smith U-Bolt Kit for Mounting 1-1/2" Square Trailer Axles #CE23102 that you referenced includes two u-bolt plates, 8 nuts and washers, and 4 u-bolts. In other words it comes with two sets and not just one like you asked.

I'd be happy to help you with that. You'll need a tow bar, base plates, safety cables, a taillight wiring harness, a supplemental braking sytem and possibly a high/low adapter. For a tow bar, I'd recommend the Blue Ox Alpha 2, part…

The spring hanger placement is going to be determined by your axle spacing. For example, if your axles are spaced 33 inches apart, as shown in the attached diagram, a 7K axle slipper spring, like #e74SR, requires a distance of 28-1/2 inches between…

The BTR and BT8 denotations refer to the spindle, not the trailer hub. The difference between a BTR and BT8 spindle is that the BTR spindle uses a 1.063" diameter L44649 bearing and the BT8 spindle uses a 0.99" diameter L44643 bearing. In…

The Husky Brute Jacks like #HT87247 had some models with remote like you referenced. You may want to start by removing the battery from the remote in case it is actually giving a slow retraction signal. Although that is unlikely, it is worth a shot.…

The LED Trailer Mini Clearance and Side Marker Light with Grommet #MCL10AKB will fit best with a wall (or bracket) thickness that is just under 5/16".

Yes, the #TJD-12000-RODNUT is the correct replacement for your 12 Ram jack. This is a replace nut and screw.