I would recommend to use the treated torx screws for ACQ (Alkaline Copper Quaternary) treated wood for better corrosion and rust resistance. The treated torx screws like the Redline 2-1/2 Inch Long Torx Trailer Screw for ACQ Treated Wood, part…
We do have a compatible grease seal for your 168255TC oil seal, however, we do not carry rubber coated seals in this size. The 168255TC oil seal was designed to work with oil bath hubs on a 3,500 lb axle. For the most part, axle manufacturers have…
The brake controller port on a 2021 Ford F-150 (if equipped) will be located behind the coin tray in the center console. This will be accessed by removing the panel under the steering wheel. I have attached a video which shows this below. For a brake…
Trailer spindle nuts, like the 1-1/2" Spindle Nut #6-96, don't have a specific torque setting. What you'll want to do is snug up the trailer nut and then back it off a little so your trailer hub has some some freedom of movement. If you…
You likely can use any replacement switch since all they do is complete a circuit when the pin is pulled out. One wire on the switch should be connected to the positive battery terminal on the trailer. The other will tee into the wiring leading from…
Good question Victor, but there is not a tool to install the Locking Ring for Optronics MCL11S Series Trailer Lights #A11SRB. You'll just push the locking ring onto the underside of the light and it'll grab on, so no tool is needed.
The left side is the driver side, right side is passenger side. On a trailer brake assembly like #23-105 the arm that the magnet is on points to the front of the trailer and the magnet always will be on the bottom. I have included a picture that…
I went out to our warehouse for you and measured the Tandem Axle Jeep Style Trailer Fenders part #HP62VR. The top part has a radius at each end so there isn't exactly a set point to measure from but I did my best to get the center of the radius…
That is correct. If your 2021 Wrangler Unlimited has the connector located under the dash to the left of the steering column near the top of the e-brake pedal as shown in the provided photo, you'd use the #3073-P harness to connect the #90195…
Trailer hub and drum assembly #8-201-5 does match your bearings. I am fairly certain you have 5,200 pound axles and not 3500 pound axles since all of the parts you need are for higher rated axles than 3500 pounds. The races come already pressed into…
I do have an option for you but Atwood is no longer in business so the only option would be a full replacement for which I recommend the Demco 50-Degree A-Frame Trailer Coupler part #DM16680-52. It features a bolt-on install, easy couple design, and…
WOW! I am impressed! I called to place my order and real person answered, spoke perfect English, albeit a slight southern accent, and my order was sent within a day, shipped quickly and I had it a few days later. I saved over a hundred dollars over local and installed it my self. I cant imagine how that they could do any better. THANKS!
Filter Results
