Hello Kurt, I can definitely help you out with the right clearance and side markers for your 6 x 12 dump trailer. I attached an image to reference for the lights/reflectors, these are the DOT requirements: - Rear reflector (#4 on diagram) 2 of the…
Hey Isaac! While we don't have one specific all in one kit we do have every component you will need to update your trailer's lighting and brakes. I recommend using the Trailer Wiring Kit item #ET7WK. This includes a 7-Way connector, a…
The light dimensions of the Optronics LED #TLL12RK are 7-9/16" long x 2-3/4" tall x 1-3/4" deep and the hole size needed is 6.75" by 2.5 inches. I confirmed this with my contact at the manufacturer and I've attached a template…
Typically 4-way wiring consists of 18 and 16 gauge wires. For a 4-way that has all 16 gauge wire you would want the Wesbar 4-Pole Flat Connector #W787264. The part #HM38138 uses 18 gauge for all wires but the white that uses 16 gauge.
Most trailer wiring that runs to trailer lights is 16 gauge. I would rather people use 14 or 12 unless the lights are LED which draw considerably less. But for most people 16 gauge works just fine for basic trailer lighting. If you are planning on…
The reason there are trailer light kits listed for under 80 inches and over 80 inches is that there are different lighting regulations for vehicles that have widths that are larger than 80 inches in width than ones that are less than 80 inches wide.…
A trailer that is over 80 inches wide is required by DOT regulations to have rear clearance lights. An over 80 inch taillight kit, like part #TL16RK, will have the side clearance light built into it. An under 80 inch taillight does not have the…
We do offer 4-pole wishbone wiring harnesses like #A35W42B and jacketed 4-pole wire such as #DW04923-1. We do not have a jacketed wishbone 4-pole trailer harness but you can certainly provide protection to a 4-pole wishbone harness - and keep the…
The RetraxPRO XR Hard Tonneau Cover w/ Trax Rails - Retractable - Aluminum - Matte #RTT-80384 has a canister that is 13-3/4 inches wide and sits 11-5/8 inches deep from the top of the bed rail. The RetraxPro and the Pace Edwards Jackrabbit…
The only hub we have that is associated with a 3/4 inch spindle is #AH15450ECOMP. This is an agricultural hub that takes inner bearing #LM67048 and outer bearing #LM11949. But the spindle it fits on is not straight, it is tapered, #TRU54FR. If this…
To convert an oil-bath hub to a grease hub all you really have to do is is remove the oil from the hub and replace it with grease like the LMX Red grease #L11390. The cap, seal, and bearings you have now are perfectly compatible with grease.
Filter Results
