Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
We do carry the 33" Ark Stabilizer Jack that you are looking for with part #ARK77FR. I was able to track down a few drawings that you should find helpful. These are for the 30" #ARK94FR and the 24" #ARK34FR Stabilizer jacks. I'm…
view full answer...Hello Monte, thanks for reaching out. Both of the springs you mentioned, the etrailer #e54SR and Dexter #DX23CR are springs for a 3,500 lb axle. The difference is the brand and the length. The #e54SR is our etrailer brand and is 25-1/8" long eye…
view full answer...If your 2011 Tundra has the factory tow package, which includes the factory installed 7-way trailer connector on the rear bumper, it will be equipped with the tow package plug under the dash, as shown in the photo I've edited for you. Some models…
view full answer...The Ark Drop Down Corner RV Stabilizer Jacks #ARK77FR is the XO corner steadies that you're referring to and in the past we were told that there was no weight capacity and that these were simply to be used to help stabilize the trailer. Looking…
view full answer...I have attached for you below a photo with the dimensions of the weld-on plate for the Ark Drop Down Corner RV Stabilizer Jack Kit part #ARK94FR. The plates are 117mm long x 72.50mm wide or 4.6" long x 2.8" wide.
view full answer...With the McHitch on your Obi Dweller 13 I have a couple recommendations since you will not be able to use a traditional weight distribution hitch. The McHitch changes the pivot point from the ball to the u-joint so it will not work properly with any…
view full answer...I was able to get the following image information from ARK for their Xtreme Off-Road Swivel Trailer Jack #ORJW750BD which shows the different lengths for the jack in the storage position depending on which setting you have it in. The overall length…
view full answer...Hey Jeanie, I think only 12" of lift is going to be a bit too short based off of your measurements. Instead, I recommend going with the Ark Xtreme Off-Road Swivel Trailer Jack w/ 2 Wheels #ARK39FR which has 24" of lift and collapses to…
view full answer...Hey Kevin! the Ark XO Drop Down Corner #ARK87FR has a support capacity of 1,925 lbs per jack. For some reason a capacity made its way onto the Ark Drop Down Corner Steadies #ARK34FR page and others like it which will need to be corrected. However,…
view full answer...Yes, the ARK Extreme Off-Road Trailer Jack w/ Dual Wheels #ORJW750BD can easily fit and work with a trailer frame that sits 23" off of the ground. In the attached photo the bottom of the trailer frame sits 19" above the ground and the jack…
view full answer...Good question, and we have asked the manufacturer, Ark, this very same question, and they have said there is not any weight rating for the Ark Drop Down Corner RV Stabilizer Jacks - 33" Long Corner Steadies #ARK77FR. They say the reason they…
view full answer...This is a great question that there isn't exactly a great answer for. Hitch extenders not only put the weight further away from the hitch which would increase the leverage on the hitch, but they also add movement to the assembly which will…
view full answer...Related Searches