Search: a2252cb > Trailer Suspension Parts >
Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
Hey Bill, welcome back! Installation of the Roadmaster Front Anti-Sway Bar #RM24RF does require drilling two 1/2" holes to mount the skid plate. These holes are in the crossmember, not in the main frame rails. The included hardware and backing…
view full answer...Hey Mike, The #IR29FR lock kit is not compatible to work with the B&W Pintle Hitch that you have. The pin diameters are different sizes and would not fit. The only kit we have that is confirmed to fit the B&W Pintle Hitch is the InfiniteRule…
view full answer...The Hopkins Quick-Lock Diodes for Towed Vehicles #HM56305 does only allow voltage to travel in one direction so it would work well for you as a way to prevent backfeeding.
view full answer...The flashing by part #CPL65A-STR is done inside the light. These lights will flash, or strobe, 4 times per second as long as 12 volt power is supplied to the circuit they are attached to. You will need a switch to activate and shut down the flashing…
view full answer...I pulled one of the units off the shelf in our warehouse and I have copied the directions that are included in the package for you. I called my contact at the manufacturer and the LEDs have a lifetime manufacturer warranty. Instructions: Your light…
view full answer...I contacted Lippert and they are not able to tell which motor you need based off of the fifth wheel model however, I can tell you where to look for the serial number of the slide out. If the slide out is a through frame the arms may have a tag with…
view full answer...We do have a couple of options to replace your Atwood 36636, and you can use either, with the only difference being the color: - RV Propane Gas and Carbon Monoxide Detector - Black #RS54FR or White #RS34FR Either will work perfectly as replacements…
view full answer...Thank you for providing the original grease seal number that you wish to replace, part #3077. This is usually the best way to find a replacement. Unfortunately, we have no cross reference for this part number. The other route to find a replacement…
view full answer...I was able to find the 126003 hub and was able to determine that it is a 3,500 lb hub/drum with a 5 on 4-1/2 inch bolt pattern just like the #AKHD-545-35-K that you referenced. This hub will work as a replacement for your Lippert.
view full answer...I understand how it would be unclear which measurement to use since the center of the axle is not the same as the center of the wheel on a torsion axle. For a single axle trailer, measure from the center of the spindle (center of wheel) to the…
view full answer...Hello Steve, thanks for reaching out. The DeeMaxx Replacement Caliper #DE52WR would not be a suitable replacement for the discontinued TDE 46802 caliper. Based on my research the TDE 46802 is for 7K-8K axles and the #DE52WR is only rated up to 6K.…
view full answer...The only thing I found on your Dexter 70-7 is the Replacement 13" Rotor for Dexter Disc Brakes #K71-631-00 which has 70-7 stamped on it. The #K71-631-00 fits 8,000 lb. Dexter disc brake kits like the #K71-646-2, #K71-646-2-91 or #K71-646-2-90.
view full answer...Filters
- 2 results
Vehicle Fit