Installation Guide for the Solera RV Slide-Out Awning on a 2019 Keystone Impact 5W Toy Hauler Video

The Solera Manual Pull Style to Power Awning Conversion Kit, Black #LC329251 will simply require changing the heads on your awning frame and then wiring the unit. I've attached the photo from the installation manual that specifies how to wire the…

The additional port on the side of the trailer is not run through the solar controller but directly to the battery/batteries. This port is actually designed for a portable kit which already has a built-in solar controller so you are perfect to go…

The Telesteps Ladder Standoff and Tool Tray #TE89FR is specifically designed to fit on Telesteps ladders like #TE44FR which have the oval vertical uprights. The uprights on the Lippert On-The-Go Telescopic Ladder #LC64HD are round and will not allow…

The Solera RV Slide-Out Awning #LCV000165063 is the correct topper for you since it will work on slide outs with a projection of up to 48". There is not one available specifically for 33" projection, but will work just the same and only…

Measuring to pick out the correct slide topper for an RV like your 2007 Damon Astoria is pretty easy. You have to measure the box width including the flange on it and you'll be set. So the Solera part #LCV000168105 that you referenced is for box…

The Solera 7.5' Slider (Slide-Topper) in Black w/ Black Hardware #LCV000165062 is the part you want. It measures 90 inches wide as you stated and fits a box that measures from flange to flange or 80 inches to 85-3/4 inches. It requires 6 inches…

It sounds like you are looking for the Solera RV Slide-Out Awning - 6'7" Wide - 48" Projection - Black #LCV000168105 which will fit your 76" slide out perfectly and has black fabric to match the picture you provided. The Solera…

The 6 inches (roughly) is on both ends. So about 12 inches total. There is a little wiggle room if you don't quite have 6 inches when installing a slide-out topper such as #LCV000168105 but not much.

Hey Dan, so the etrailer bumper cargo carrier part #e99050 that you referenced is designed to attach to 4 inch or 4-1/2 inch square bumpers. If you have an I-beam crossmember that is 4 inch or 4-1/2 inch square I could see this working potentially…

The reverse light pin on a traditional 7-way trailer connector, like part #PK11893 or a factory connector if that's what you have on your 2018 Ram, is the center pin. Take a look at the picture I attached that shows all the pin functions. To add…

You should have continuity between the 5 o'clock brake output pin and 7 o'clock ground pin in your 7-way connector with the brakes applied. I recommend turning the trailer brake controller to its max setting and having someone apply the…

There is one fuse location and two relay locations you will want to check in the power distribution box in the engine compartment. First, check the 20-amp fuse in location 45. This is the Trailer tow stop turn relay feed. If that checks out fine,…