Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
Hi David; the Velit 2000R Mini RV AC #VE49QV wiring harness is 15' long. However, the length isn't a major concern since you can simply extend it with additional 6 AWG wire if needed. Are you converting this into a camper van?
view full answer...You can use the RV Propane Gas Detector #RS64FR (white) or #RS44FR (black) to replace your current Atwood 31013 propane gas detector. This will also use a 12v, 2-wire installation like your current detector.
view full answer...Yes. They are the same part with different base and hitch balls being the only difference. You can swap the hitch ball on the Trailer Valet XL #TVXL25 using the #TVBB2, which would be ideal for switching hitch ball sizes more frequently since it…
view full answer...To convert your Trailer Valet XL part #TVXL25 to a 2 inch ball you would need the part #TVBB2 which will allow you to easily replace the base with a new ball that is 2 inches. You would be able to easily go back to the larger ball size as well. The…
view full answer...The Trailer Valet XL Trailer Dolly part #TVXL25 that you referenced uses a solid rubber tire, part #TVXLSR so there would be no inflation valve to add air. However, I think you might have the Trailer Valet 5X Swivel Jack and Trailer Mover part…
view full answer...It looks like a Hayes Brake magnet part number 73400. We do not carry this part but I did a quick internet search and was able to find a couple places that sell them. From the research I did it looks like this is an older style of brake magnet used…
view full answer...Those are some good options, and the best overall upgrade (without getting too crazy like you said!) for your Jayco with tandem 3,500 lb axles is going to be the MORryde CRE3000 with the X-factor crossmember. The Road Armor is good, but the…
view full answer...It would the easiest if you just replaced the bolt you have with the part #34007-187-00 which is the correct bolt replacement for your EZ Flex equalizer part #K71-358-00. The zerk fitting replacement info is not available.
view full answer...I reached out to the manufacturer and the Wet Equalizer Bolt with Locknut and Grease Zerk for Double-Eye Springs - 3-5/16" Long #126B2 is a pressed in zerk fitting, so it cannot be replaced. This is also true for Dexter bolts as well. There are…
view full answer...It sounds like there might just be a clog in either the Zerk fitting or line of the wet bolt preventing grease to pass through. Aside from removing it and trying to clean it out replacement would be the only other option. Depending on the length of…
view full answer...Yes, the Grease Zerk #LC44XV for your Lippert Tandem Axle Equa-Flex AP Kit #LC64FR can be replaced as it is removable. Do note that this grease zerk is specific to Lippert as it has a special tapered thread that is not commonly used by other…
view full answer...