Search: Trailer Lift Kit   >   !Camper Jacks   >   !Electric Winch   >   Snow Plow   >  

Hey Jaime, yes you can replace your 25-1/4 inch 3,500 lb axle leaf springs with a 5k rated axle spring like the part #e44SR. This will increase the suspension's weight capacity and might make the ride quality a little rougher but it would fit and…

You are doing the right thing by doing the research first. There is a lot of conflicting information out there so let me break it down for you and I will provide some part recommendations at the end. Basically, if you want to tow a 5th wheel trailer,…

I can tell you how to determine the correct spindle based on your measurements, and what you will need is a digital caliper, though the first thing you need to know is the weight rating of your trailer axle. From there, what you need to do is measure…

The widest tire size that fits a 12 inch wheel is the 145/80-12 like the part #AM10140 which has a section width of 5.7 inches. This will be right at an inch wider than what you currently have.

The ID and Password you need to link your Lippert Ground Control 3.0 item #LC675817 system to the app on your phone can be found on the gateway inside your 2021 Cougar 290RLS. You have the antenna to connect wirelessly but if you don't have the…

The Curt E5 Fifth Wheel Hitch you referenced, part #16516 would be a good choice for your 2001 Sierra if it is equipped with the 6-1/2 foot bed. The E5 features a 4-way pivoting head and a non binding round tube slider. If you have the 8 foot bed,…

We do have lift kits for trailers with Dexter Torflex Torsion Axles however, I don't have any information on what specific axles your trailer is equipped with so you will need to find out what axle is one your trailer either by calling the…

It looks like the studs in your brake assembly are closer together (center to center) at the bottom. If the center to center bolt spacing matches the photo I've provided, then the #23-105-09 you'd looked at would be the correct replacement…

Pin box bolt torque is based on the size of the bolts. 1/2 inch Bolts GR5 90 ft-lbs 5/8 inch Bolts GR5 150 ft-lbs 3/4 inch Bolts GR5 275 ft-lbs

MORryde has a version of the X-Factor Crossmember that was designed to work with the CRE3000 you have with the part #MR33WR.

If you had the clearance for a 14 inch wheel and tire yes you could upgrade your 12 inch setup to a 14 inch setup. The tire diameter would increase from 21.3 inches to 26.3 inches and the width would increase by 2.3 inches. For that we have the Kenda…

Assuming you are looking for a 2,200 lb axle you can use the Trailer Axle with Idler Hubs - 5 on 4-1/2 Bolt Pattern - 60" Long - 2,200 lbs #e94YR. If you do not need the hubs then we also have the Trailer Idler Axle Beam with Easy Grease…