Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
To install your Reese Pod brake controller in your 2018 Ford Explorer will require the install harness part #3035-P which is a confirmed fit. If you check out the 9:55 mark of the install video I attached to this page you'll see where to find…
view full answer...The hanger spacing for the #APT4 with 25-1/8" leaf springs is 27-3/4" on center. I have attached a drawing for your reference.
view full answer...Yes, I attached an install video that shows the Pollak part #PK12-707E (same as number you mentioned) installed in a newer GMC to this page.
view full answer...The Rubber Lube Plug - Fits 1.18" Lubed Dust Cap #DC-RP is the replacement for the #RG04-040 grease cap as well as larger caps like the 2.44" OD Drive In Grease Cap with Plug #RG04-080. The Grease Cap Plug fro E-Z Lube Grease Caps…
view full answer...If your trailer has 7 wires running all the way back to the brakes, then yes, you can tap into the existing wiring. Each of your new brakes will have two wires for the brake magnet. One wire is for 12 volt power to the brake magnets and the other…
view full answer...The brown relay is the correct one for activating the 12 volt accessory circuit of a 7-way on your 2017 Nissan Titan. With the part #C57000 you will get this relay as well as two additional blue relays. Most likely replacing the relay is what will…
view full answer...We do have the correct replacement inner member for your LP7500 actuator, which is the following part: - Replacement Inner Member for Dexter DX7.5L Actuator - Single Axle with Disc - 2" Ball - 7,500 lbs #DX39FR This is the replacement for…
view full answer...The correct replacement motor for your Rs-385phc2-17100b Vdo218-00 Kinmore Vent is going to be the Replacement 12V DC Motor for Ventline, Ventadome, and Vanair Fans Item #BVD0218-00.
view full answer...Based on the numbers provided and the description of the parts fan motor #BVD0218-00 is the correct replacement motor. The numbers you see on this fan are different because Ventline updated the motor but it still fits the same vents as the old…
view full answer...The center hangers in the Tandem-Axle Trailer Hanger Kit #APT8 that you recently purchased are indeed longer. This is actually pretty common for tandem axle trailers. The reason for the extra length on the middle hanger is related to the shackle…
view full answer...The spindle that is on the Dexter Trailer Idler Axle w/ Idler Hubs #20440I-EZ-60 is a BTR spindle like part #TRU44FR. . The stub diameter (A) on the TruRyde spindle is 1-1/4 inches, The part where the grease seal rides (B) is 1.5 inches. It uses…
view full answer...The grease for the Dexter Trailer Idler Hub Assembly for 2,000-lb Axles #34822545BX is a lithium grease like the Dexter Multi-Purpose Lithium Grease #DX64TR. The hub comes pre-greased so you do not need at add any more when installing. Then in…
view full answer...Filter Your Search
Contact and Help