R1S x > RVR x > Rabbit x > R-Series x >
Recommended Tire Chains for a 2023 Rivian RS1 275/50 R22
Hello, I’m looking for low profile 16mm or smaller snow chains/cables for my 2023 Rivian RS1 275/50 R22. Would these work? Thanks! | Hey Julie, thanks for the information and the picture! I checked with Rivian and we've only got one set of tire...
Would Thule Hullavator Work With Rivian R1S OEM Roof Rack?
Im trying to install the Thule Hullavator on a Rivian R1S. I already have the Rivian Cargo Crossbars so Id prefer to use these if possible. The Hullavator requires the crossbars to overhang and the Rivian Crossbars dont. Is there a way to stackinch...
Which Kat's Block Heater Fits 2025 Mitsubishi Outlander SE 2.5 Liter
Will this heater work, without modification, on my 2025 Mitsubishi Outlander SE? Please confirm the location for this vehicle as well. | Hey James, yes the Kat's Heater part # KH11812 that you referenced is a confirmed fit for your 2025 Mitsubishi...
Where Do You Measure From On The Trailers Coupler to Install The Pole-Tongue Adapter # EQ95-01-5950?
For the tongue pole adaptor, you mention in the video that it need to be install between 27 to 32 inches from the reveiver in the tongue. Do we mesure from the tip of the receiver or the middle, because if I mesure from the tip of the receiver...
Recommended RV AC Unit for 2001 R Vision Condor
I have a 2001 R Vision Condor, I have a Duo-Term 15000 BTU AC ducted unit that does not work. Model No. 59516.531, Product No. 991731786. I need to replace it. My thermostat controls the AC and Heat. What will work, do I need more than just...
Why Choose a Powered Taillight Converter Over a Non-Powered Model
What dictates the need between using a powered Tail light convertor Vs a non powered? | There's a couple of factors that determine that. On older vehicles, very few vehicles needed a powered converter, because the vehicle's electrical system...
Will etrailer Spare Carrier # e98ZR Work with Rivian R1S 20
Does this fit a rivian r1s 20 inch all terrain tire? 275 / 65 / R20 | Hey John, yes the etrailer spare tire mount part # e98ZR that you referenced will work with the wheel and tire Rivian R1S 20 inch all terrain tire that you referenced. |
Recommended Brake Controller For A 2004 Holiday Rambler Admiral
Hello i am trying to put à brake contrôler on my Amiral Se holyday Rumbler Workhorse 2004 Do you know if there is plug already for that That you n’écoule ont thé brake switch and able to get 12 volts ??? Marcel from Québec Canada Tank you...
How to Tell if Power Mountain Tallboy Off-Road Bottle Jack Will Work with a 2023 Rivian R1S
what jack can you recommend for changing tires on my Rivian R1S 2023 and Intech Sol Dusk Rover off road package travel trailer? Will the Tallboy pm34fr work with a Rivian puck? | Hey Darin, thanks for reaching out! The Power Mountain Tallboy...
Troubleshooting Wiring for Coach Step Not Showing Power
I used a volt meter to figure out a power issue with the chassis wiring. Red wire should be a 12-14v output, but it reads between 1v and 5v. problem 1 identified. Problem 2: Purple wire when connected will blow the 7.5 Switch Fuse when switch...
Does The GE Appliances RV Refrigerator GE58FR Come With A Mounting Bracket?
Does this with mounting brackets? | Hello Raymond, thanks for reaching out. The mounting brackets are not included with the GE Appliances RV Refrigerator # GE58FR. It requires a GE approved top bracket part BMT-GPV10. This is not something we...
Replacement Jack For 2001 Stratos Bass Boat Trailer
I have a 2001 Stratos Bass boat with a Fulton center bolt swivel jack onto a welded plate on the trailer. I would like to upgrade to the Fulton F2. My holes on the plate are 3X3 on center. Will the F2 work? Can I send you picture? Thank You...
What is the Battery Life for Hopkins Wireless Magnetic Tow Lights
What is range of battery life for these lights? The check battery level indicator light every 2 hours statement has me concerned. I drive for much longer stretches than that and dont wish to carry excessive spare AAs or replace them every couple...
Installation Instructions for Wiring a 2008 Volkswagen Rabbit to Tow a Trailer
My question is about the electical hook-up. Can I splice a 4-flat connector directly into the wiring harness, or do I need some kind of powered module dure to the fact that it6 haqs LED lights? | Due to the MX (Multi-Plexed) wiring system on...
Why is a Stabilizing Strap Recommended on Curt Hitches and what is Meant by Non-Trailer Load
What is meant by stabilizing straps for non-trailer loads? | Non-trailer loads are hitch accessories like bike racks and cargo carriers. Basically anything that is not a trailer that you could put on a hitch. Curt recommends you use a Curt Trailer...
Can The 2022 Honda CRV 2WD Be Dolly Towed
I have a new 2022 Honda CRV 2 WD. Can I tow this on a tow dolly? If so which wheels are on the ground? | According to the owner's manual for the 2022 Honda CRV a 2WD model can be dolly towed with the front two wheels up on the dolly. The Roadmaster...
Torque Specs for the B&W Heavy-Duty Trailer Hitch Receiver BWHDRH25198
what is the tourque spec for the 4 mounting bolts? | Hey David. The four mounting bolts on the sides of the B&W Heavy-Duty Trailer Hitch Receiver item # BWHDRH25198 need to be torqued to 80 ft-lbs. The Grade 8 1/2"-13 coarse thread bolts that...
Replacement Curt Trailer Hitch Hardware Kit for a 2009 Volkswagen Rabbit
Hi - I recently received a CURT C11074 Trailer hitch for the 2009 VW Rabbit from a friend who no longer has their MK5 rabbit. Is it possible to purchase *only* the replacement mounting hardware for this specific mount instead of the generic...
Trailer Hitch and 4-Way Wiring Recommendation for 2018 Mitsubishi Eclipse Cross
I need a hitch and 4 wire harness for a 2018 mitsubishi eclipse cross | For your 2018 Mitsubishi Eclipse Cross we have the Curt hitch # C13273 which is a confirmed fit and then for 4-way wiring you'd want the part # C56296 and you'd be set. |
Is Trimming of the Foam Absorber Required for the Curt Hitch On a 2010 Mini Cooper Convertible
have a question about hitch and hard form . I removed the bumper today for preparation for hitch installation. The bumper has the hard foam but it is wedge between the front and back metal bumper with a full metal back hard foam cannot be...
Why It's Easier to Replace Valterra Waste Valves on RV with Valterra Valves
I bought two valves from you at the beginning of march. 3inch and 1-1/2 now that the motor home is out of storage I went to start replacement of the valves. I took out the 1-1/2 first I found out that the Lasalle bolt pattern is different...
Trailer Hitch and Wiring Recommendation for 2022 Mitsubishi RVR
Hi there I just bought a 2022 Mitsubishi RVR and wanted some clarification on what hitch and wiring I need? Could you send links? Also there’s no videos for install? Thanks | For your 2022 Mitsubishi RVR the e63AR Hitch part # e63AR is the...
How to Prevent Exhaust Components from Contacting the Trailer Hitch
I purchased the replacement CURT trailer hitch hardware from eTrailer for this hitch and installed the 11074 on my 2009 4DR Rabbit. However - after install, I now experience a lot more noise at low RPMs. Theres vibration being transmitted back...
Troubleshooting Turn and Brake Lights not Working with Running Lights on, 2009 Volkswagen Rabbit
I have the same problem than the VW GTI guy. After I have wired the kit according to the 2-wire method into my 2009 Rabbit, turn and stop light are working as long as the running light is not on. I have tried also the different 3-wire methods...
Filter Your Search
Contact and Help