Result: knobs

Have power at the controller, no lights at the knob. | Have power at the controller, no lights at the knob. | I would start by using a hook probe tester like the # PTW2993 to check and see if you're getting a power feed on the...

If you instead went with the Junior Latch part # L1883 you could then use the knob part # 4PLSP but there isn't a knob solution for the # N1980. | Will the inside doorknob fit or can be used on the N1980 Junior...

| The Inside Knob for Locking Stainless Steel Flush Door Latch # 4PLSP has a 1/4"-20 thread pitch. | Could you please tell me the thread pitch of this knob as i am trying to match it to a latch i have and would like to make...

I called my contact at Redline and the knob that can be used on the inside of the door is part # 4PLSP. | Can you buy an inside release for this? If so, how can you get one? | The Steel Flush Door Latch, part # N3980 has a threaded...

Another option is basically the same door latch that comes with the knob already in place. It is # L1833. | Does this open from both sides? | The Locking Stainless Steel Flush Door Latch, # L1883, has a threaded hole on the...

Can this latch be opened using the inside release knob when the lock is locked? Or does the lock prevent opening from the inside as well? | Can this latch be opened using the inside release knob when the lock is locked? Or...

Do you have a replacement Knob for a Fulton jack handle I know you offer 2 replace handles...but just wondering if a Knob is available? | Do you have a replacement Knob for a Fulton jack handle I know...

Is this knob the ground connection or what is the difference between the adapators that do or dont have this knob? | I have a 2003 4 Runner with tow package the factory hitch connection is 7 flat. I have a...

If you need to obtain multiple locking flush door latches then you will want to use the Full Size Locking Steel Flush Door Latch part # L3980 as they all come with the same key. The inside door knob can then be added with the Inside Knob for Locking Stainless Steel Flush Door Latch part # 4PLSP. |

To level the sensor, you will set the power knob to maximum by fully rotating it clockwise (with the trailer connected). | Light on controller goes from green to a light green. No assist. Will not adjust with the riflght diel....

I made you a short video that shows how to replace the knob provided that the little tabs on the back of the knob or where they mount are not damaged. | While installing and checking operation, as I activated...

You are going to want the Redarc Tow-Pro Liberty Brake Controller w/ Universal Wiring Harness - Dash Knob - Proportional # RED52VR, don't forget to grab a Universal Mounting Panel for Redarc Tow-Pro Trailer Brake Controller Control Knob # 331-TPSI-001 for one of those empty spots on your dash. |

As a test I held the P2 at no upward angle in my hand and applied the manual power knob, with no increase / improvement in braking power. | Hello eTrailer. I recently installed the Prodigy P2 Brake Controller on my 2017...

Check to be sure that the power knob is not set all the way to the lowest position. | I just hook up a pilot controller and if i hit the break pedal the dot in the middle lights up, but if i use the button on the controller...

Now for installing the knob of the controller you will need to pick a spot that you have at least 3/4" clearance for the knob, and 1-3/4" space behind the location for the back part of the knob to have enough clearance. |

Will this knob fit a 1979 Rockwood pop up tent trailer door | Will this knob fit a 1979 Rockwood pop up tent trailer door | Valterra Keyed Entry Door Knob # L32CS000 is made to fit RV and mobile home doors that are 1-3/8 to...

It has a manual slide, a power knob on the right and another knob on the left. | Its a Journey model # 527408045 approx. 7 yrs. old. I lost my manual and want to set it up for a new trailer. Is there a manual...

Also no lights on the control knob! | How do you make the brake controller think it is connected to a trailer with brakes? Just to make the unit light up. I have no lights on the control knob. I do lights on the tester for...

Then rotate the Level Knob clockwise until you see a shade of orange on the light. | I have the four wires hooked up, have power to the controller. But it doesnt go from green to orange/red when I try leveling the sensor....

The main unit measures 3-3/8" long x 3-15/16" wide x 1-1/8" tall and the control knob measures 2-3/8" long x 3/4" wide x 7/8" tall. | Im interested in Redarc Tow-Pro Elite # RED44FR because the control can be hidden and placed...

This is with the power knob all the way clockwise. Thanks | My green light looks like its on with trailer disconnected but when my trailer is connected the green light is much brighter. Also, I was trying to adjust my level...

WHEN CONNECTED TO VAN GREEN LIGHT IS ON WHEN EMEGENCY BRAKE IS APPLIED ,LIGHT TURNS RED WHEN FOOT BRAKE IS APPLIED LIGHT STAYS GREEN NO MATTER WHERE THE POWER KNOB OR LEVEL KNOB IS. WHAT IS THE PROBLEM? | WHEN...

In order to open the Full Size Locking Steel Flush Door Latch part # L3980 from inside the trailer you will want to use the Inside Knob for Locking Stainless Steel Flush Door Latch part # 4PLSP. | Does this come with interior...

I see that the Redarc has a separate adjustment knob that you mount wherever desired. The knob then plugs into the control box and the Ranger factory wiring gets spliced into a 4-wire pigtail that then plugs into the controller to complete the installation. |