Result: knobs

Have power at the controller, no lights at the knob. | Have power at the controller, no lights at the knob. | I would start by using a hook probe tester like the # PTW2993 to check and see if you're getting a power feed on the...

Is this knob the ground connection or what is the difference between the adapators that do or dont have this knob? | I have a 2003 4 Runner with tow package the factory hitch connection is 7 flat. I have a...

We have a couple of other mounting options for the control knob that can go inside inserts in your dash. The Universal Mounting Panel for Redarc Tow-Pro Trailer Brake Controller Control Knob item # 331-TPSI-001 which measures 1-1/4 by 1 inch. |

To level the sensor, you will set the power knob to maximum by fully rotating it clockwise (with the trailer connected). | Light on controller goes from green to a light green. No assist. Will not adjust with the riflght diel....

I made you a short video that shows how to replace the knob provided that the little tabs on the back of the knob or where they mount are not damaged. | While installing and checking operation, as I activated...

You are going to want the Redarc Tow-Pro Liberty Brake Controller w/ Universal Wiring Harness - Dash Knob - Proportional # RED52VR, don't forget to grab a Universal Mounting Panel for Redarc Tow-Pro Trailer Brake Controller Control Knob # 331-TPSI-001 for one of those empty spots on your dash. |

Be sure to determine a location on the dash where you will be mounting the actual controller knob so the cable from the control knob can reach the control module mounting location under the dash. | Thanks...

As a test I held the P2 at no upward angle in my hand and applied the manual power knob, with no increase / improvement in braking power. | Hello eTrailer. I recently installed the Prodigy P2 Brake Controller on my 2017...

Check to be sure that the power knob is not set all the way to the lowest position. | I just hook up a pilot controller and if i hit the break pedal the dot in the middle lights up, but if i use the button on the controller...

This brake controller has a super small control knob that you can hide in the dash instead of a brick to hit your knee on. | Do you have a brake controller compatible with a 2019 Lincoln Nautilus? | Hey Gary, For your 2019...

Now for installing the knob of the controller you will need to pick a spot that you have at least 3/4" clearance for the knob, and 1-3/4" space behind the location for the back part of the knob to have enough clearance. |

The main unit mounts out of site so only the control knob is visible in the cab. The knob controls the braking power and also acts as the manual override. | Do you have a 7 pin flat trailer wire harness for...

i have checked for power to the controller it has power i plug in the trailer the light is green i turn the knob fully clockwise light stays green i press the pedal still stays green i checked for signal on the red wire no signal i press the brake there is signal i pull the manual lever to the left the light turns red i hear the power at the brakes ,can you help me know why my light doesnt turn red when i turn the knob all the way to the right and press the pedal? |

It has a manual slide, a power knob on the right and another knob on the left. | Its a Journey model # 527408045 approx. 7 yrs. old. I lost my manual and want to set it up for a new trailer. Is there a manual...

Even when I apply the manual slide knob, the brakes will not lock up. Any ideas? | Hi, I have a 2005 Fleetwood Victory pop-up tent trailer. I recently had new brakes installed and ever since then, the trailer brakes are weak....

Also no lights on the control knob! | How do you make the brake controller think it is connected to a trailer with brakes? Just to make the unit light up. I have no lights on the control knob. I do lights on the tester for...

Then rotate the Level Knob clockwise until you see a shade of orange on the light. | I have the four wires hooked up, have power to the controller. But it doesnt go from green to orange/red when I try leveling the sensor....

The main unit measures 3-3/8" long x 3-15/16" wide x 1-1/8" tall and the control knob measures 2-3/8" long x 3/4" wide x 7/8" tall. | Im interested in Redarc Tow-Pro Elite # RED44FR because the control can be hidden and placed...

The main unit installs behind the dash so only the control knob is visible. The knob controls the brake power and also acts as the manual override. | Maam / Sir, I have a 1997 K3500 Crewcab Dually...

This is with the power knob all the way clockwise. Thanks | My green light looks like its on with trailer disconnected but when my trailer is connected the green light is much brighter. Also, I was trying to adjust my level...

If you don't already have a brake controller then I recommend going with the Curt Spectrum # C51170 because it is a proportional brake controller that allows you to install it in a variety of locations and the control knob looks similar to other control knobs on your Frontier. |

WHEN CONNECTED TO VAN GREEN LIGHT IS ON WHEN EMEGENCY BRAKE IS APPLIED ,LIGHT TURNS RED WHEN FOOT BRAKE IS APPLIED LIGHT STAYS GREEN NO MATTER WHERE THE POWER KNOB OR LEVEL KNOB IS. WHAT IS THE PROBLEM? | WHEN...

The Tow-Pro Elite brake controller is pretty unique because it can be installed virtually anywhere and you only need access to the 3/4" diameter control knob. The control knob has LED lighting integrated into it that changes colors depending on what settings you have chosen. |

I see that the Redarc has a separate adjustment knob that you mount wherever desired. The knob then plugs into the control box and the Ranger factory wiring gets spliced into a 4-wire pigtail that then plugs into the controller to complete the installation. |