Which Kat's Block Heater Fits 2025 Mitsubishi Outlander SE 2.5 Liter
Will this heater work, without modification, on my 2025 Mitsubishi Outlander SE? Please confirm the location for this vehicle as well. | Hey James, yes the Kat's Heater part # KH11812 that you referenced is a confirmed fit for your 2025 Mitsubishi...
Why Choose a Powered Taillight Converter Over a Non-Powered Model
What dictates the need between using a powered Tail light convertor Vs a non powered? | There's a couple of factors that determine that. On older vehicles, very few vehicles needed a powered converter, because the vehicle's electrical system...
Trailer Hitch and Wiring for 2009 Mercedes R320 Diesel
I have a 2009 mb R320 diesel w251 . The information on the web site indicates the class 2 trailer hitch and separate wiring packages are for a r350 MB the wiring package is with brake controller and 7 way. Can to clarify the correct products...
Replacement Control Panel for Lippert Leveling System with Module 175226
What touch panel will work with Lippert leveling control 175226/12656 ? | If you have the module part # LC175226 the correct replacement touch panel would be the # LC421484. |
Diagram of the Portion of the Fascia that Needs Trimmed to Install Curt Hitch # C13103
do you have a sketch of how much to trim do you cut around hitch support bar ? | I attached a copy of the installation instructions for the Curt hitch # C13103 which is confirmed your 2007 Mercedes R350. The installation instructions have...
Does The GE Appliances RV Refrigerator GE58FR Come With A Mounting Bracket?
Does this with mounting brackets? | Hello Raymond, thanks for reaching out. The mounting brackets are not included with the GE Appliances RV Refrigerator # GE58FR. It requires a GE approved top bracket part BMT-GPV10. This is not something we...
Does the UFP A-60 Surge Brake Actuator Require Lubrication on Inner Slide Member
Does the ufp a60 actuator need any lubrication on any of the of the moving parts on the inner slide? | I looked up the manual online for the UFP A-60 Surge Brake Actuator and found the following bullet points for greasing. "Lightly grease rear...
Should Radial or Bias Tires be Used for a 3500lb GVWR Pop Up Camper Trailer
Vehicle - 2011 Coleman Sun Valley pop up camper. Fully loaded - 3500lbs I cant seem to figure out which tire to get. It seems there is much debate on trailer tires, whether to get radials or bias ply. My stock tires are Kenda ST185/80D13-D and...
Replacement Jack For 2001 Stratos Bass Boat Trailer
I have a 2001 Stratos Bass boat with a Fulton center bolt swivel jack onto a welded plate on the trailer. I would like to upgrade to the Fulton F2. My holes on the plate are 3X3 on center. Will the F2 work? Can I send you picture? Thank You...
What is the Battery Life for Hopkins Wireless Magnetic Tow Lights
What is range of battery life for these lights? The check battery level indicator light every 2 hours statement has me concerned. I drive for much longer stretches than that and dont wish to carry excessive spare AAs or replace them every couple...
Installation Instructions for Wiring a 2008 Volkswagen Rabbit to Tow a Trailer
My question is about the electical hook-up. Can I splice a 4-flat connector directly into the wiring harness, or do I need some kind of powered module dure to the fact that it6 haqs LED lights? | Due to the MX (Multi-Plexed) wiring system on...
Why is a Stabilizing Strap Recommended on Curt Hitches and what is Meant by Non-Trailer Load
What is meant by stabilizing straps for non-trailer loads? | Non-trailer loads are hitch accessories like bike racks and cargo carriers. Basically anything that is not a trailer that you could put on a hitch. Curt recommends you use a Curt Trailer...
Trailer Hitch for a 2012 Mercedes R350 BlueTec
Will this hitch also fit the Mercedes 2012 R350 Blue Tech diesel model? Also, where is the best place to get the hitch installed once I buy it? I doubt that a dealer would do the work but I am afraid to trust non-Mercedes technicians, especially...
Is Cutiing Required for Installation of the Mercedes-Benz R350 Trailer Hitch # C13103
I would like to know if there is any cutting of the oem bumper required in order to fit your trailer hitches? | You will not need to cut the OEM bumper for installation of the Curt Trailer Hitch, item # C13103, for the 2008 R350 by Mercedes-Benz....
Removal of Fascia on Mercedes 2008 R350 When Installing a Curt Trailer Hitch, Part # C13103
Once I get the facia off, I can install the hitch. Any tips? Ive removed the 4 bolts under the rear bumper. How do I get the rest of the facia off? CURT 13103 model hitch. | I spoke with my contact at Curt and he informed me that the underbody...
What is the Pin Diameter of 4-Leaf Double-Eye Spring for 4,000-lb Trailer Axles - 26" Dacromet
What is pin diameter on e48sr leaf spring? | The 4-Leaf Double-Eye Spring for 4,000-lb Trailer Axles part # e48SR is designed for a 9/16" diameter bolt like the Zinc Shackle Bolt with Locknut part # TRFA73Z916DLNZ. If you were to remove the...
Ground Clearance of Curt Hitch Installed on 2008 Mercedes Benz R320 CDI
Is the car just too low for a hitch? | For your 2008 Mercedes Benz R320 CDI we have the Curt hitch part # C13103 as a confirmed fit. This will fit your vehicle will and will not sit too low at all. When we installed this hitch on a similar 2006...
Replacement Curt Trailer Hitch Hardware Kit for a 2009 Volkswagen Rabbit
Hi - I recently received a CURT C11074 Trailer hitch for the 2009 VW Rabbit from a friend who no longer has their MK5 rabbit. Is it possible to purchase *only* the replacement mounting hardware for this specific mount instead of the generic...
Availability of Hitch for 2006 Mercedes R500
Does this fit a 2006 Mercedes R500? | We offer two different Class III hitches that are a fit for your 2006 M/B R500. Both the Curt # C13103 and the Draw-Tite # 75470 offer a 3500 lb towing/ 350 lb tongue weight capacity, but the warranty requirements...
Is Trimming of the Foam Absorber Required for the Curt Hitch On a 2010 Mini Cooper Convertible
have a question about hitch and hard form . I removed the bumper today for preparation for hitch installation. The bumper has the hard foam but it is wedge between the front and back metal bumper with a full metal back hard foam cannot be...
Highest BTU Rating Available for Camco Olympian Wave Heater
Hi, I would like to know if the CAM57351 heater is CSA Canadian Standard Association approved. Also, do you have another propane heater option with higher BTU? I am looking for a 10,000 to 12,000 BTU heater. Thanks, | The highest BTU rated...
Trailer Hitch and 4-Way Wiring Recommendation for 2018 Mitsubishi Eclipse Cross
I need a hitch and 4 wire harness for a 2018 mitsubishi eclipse cross | For your 2018 Mitsubishi Eclipse Cross we have the Curt hitch # C13273 which is a confirmed fit and then for 4-way wiring you'd want the part # C56296 and you'd be set. |
Will the Thule Pulse XL Roof Cargo Box Fit on the Factory Crossbars on a 2011 Mercedes R350
Hi, I am planning to purchase the Mercedes Benz Basic Roof Rackinch for my 2011 R350. I would like a roof cargo carrier that will work with the Mercedes Benz rack. Will this box fit on the MB Basic Roof Rack?inch The MB Roof Rack has a channel...
Trailer Hitch and Bike Rack for 4 Bikes for a 2018 Mitsubishi RVR
I have a 2018 RVR. Can you recommend a hitch for a bike rack, 4 bikes, and a bike rack? No towing. And I don't want to have to use any straps if possible. | I will be happy to help. For your 2018 Mitsubishi RVR I recommend etrailer Trailer Hitch...
Filter Your Search
Contact and Help