Recommended Equipment for Towing a Trailer with a 1993 Buick Roadmaster
I tow a 6x12 single axle trailer with my Silverado which has a 2 inch receiver class III hitch. I need a hitch for my 93 Roadmaster sedan Limited that has a 2 inch receiver but I do not see any Class III I do not need the load carrying ability...
Which Kat's Block Heater Fits 2025 Mitsubishi Outlander SE 2.5 Liter
Will this heater work, without modification, on my 2025 Mitsubishi Outlander SE? Please confirm the location for this vehicle as well. | Hey James, yes the Kat's Heater part # KH11812 that you referenced is a confirmed fit for your 2025 Mitsubishi...
Why Choose a Powered Taillight Converter Over a Non-Powered Model
What dictates the need between using a powered Tail light convertor Vs a non powered? | There's a couple of factors that determine that. On older vehicles, very few vehicles needed a powered converter, because the vehicle's electrical system...
Class 3 Trailer Hitch For A 1994 Buick Roadmaster Estate Wagon
Hi, Do you make a class III hitch for 5K pound capacity for a 1994 Buick Roadmaster Estate Wagon ? | Hi Daniel, nice car! We do have an option that may fit your 94 Buick Roadmaster Estate Wagon, but it doesn't look like there is a custom...
Finding Installer for Curt Hitch on 2009 Kia Rondo
A Curt Trailer Hitch Receiver for a Kia rondo 2009 what car brands aré compatible to install the tráiler Hitch | Hey Adrian, I attached a link to an installer locater that you can use to find someone to install the Curt hitch part # C11031 on...
Parts Needed to Add Brakes to 1992 Coleman Arcadia Pop-Up Camper
I want to add brakes to my 92 Coleman Arcadia pop-up. I am looking for the correct hub/drum and electric brake assemblies. The wheel bolts are 5 on 4 1/2 and the tires are Carlisle USA Trail 20.5x8-10. The current axle includes a square flange...
Availability of Class III Hitch for 1996 Buick Roadmaster Estate Station Wagon
I have a 1996 Buick Estate Wagon. Looking for a class 3 receiver. Has to fit the wagon not sedan......thanks | We do offer a Class II hitch for the 1996 Buick Roadmaster Estate Wagon with a respectable 3500 lb towing/350 lb tongue weight capacity,...
Is There a Class III 2" Trailer Hitch Receiver Available For a 1995 Buick Roadmaster?
Do you sell class 3 hitch for 95 buick roadmaster with tow package? | The Curt Trailer Hitch Receiver # C12009 class II receiver is our only custom fit receiver for your 1995 Buick Roadmaster. There are a couple ways you can get to a 2" opening...
Does a Trailer Hitch Mounted Cargo Carrier Require a Light Kit on a 1995 Buick Roadmaster Wagon
Do I need to have lights wired to my car 95 Buick Roadmaster wagon if the cargo carrier isnt wide enough to obscure the tail lights? | If the cargo carrier and the cargo loaded on it do not obscure the vehicle tail lights, you do not have to...
Recommended Trailer Hitch for 1994 Buick Roadmaster Estate Wagon
I have a 1994 Buick Road master wagon and have been searching for a class 3 trailer hitch without success. Im interested in possibly purchasing your Draw tite class 3 item#75676 which I noticed stated it May Not fit my wagon. My wagon is built...
Does The GE Appliances RV Refrigerator GE58FR Come With A Mounting Bracket?
Does this with mounting brackets? | Hello Raymond, thanks for reaching out. The mounting brackets are not included with the GE Appliances RV Refrigerator # GE58FR. It requires a GE approved top bracket part BMT-GPV10. This is not something we...
Differences Between Class II and Class III Trailer Hitches
What is the exact difference between a class 2 and class 3 hitch for a 1996 Buick Roadmaster Estate Wagon? Is it strength of materials or design or both? Can I purchase fabrication drawings and specification specifics from you? Any help...
Replacement Jack For 2001 Stratos Bass Boat Trailer
I have a 2001 Stratos Bass boat with a Fulton center bolt swivel jack onto a welded plate on the trailer. I would like to upgrade to the Fulton F2. My holes on the plate are 3X3 on center. Will the F2 work? Can I send you picture? Thank You...
Can Hopkins Trailer Wiring Kit Cause 1996 Buick Roadmaster Fuel Pump to Stop Working
I used this harness and on my 96 Buick Roadmaster Wagon and followed the instruction where to plug into which side and also attached the white ground. After install this causes my fuel pump to no longer work until I unplug it and plug the tail...
What is the Battery Life for Hopkins Wireless Magnetic Tow Lights
What is range of battery life for these lights? The check battery level indicator light every 2 hours statement has me concerned. I drive for much longer stretches than that and dont wish to carry excessive spare AAs or replace them every couple...
Why is a Stabilizing Strap Recommended on Curt Hitches and what is Meant by Non-Trailer Load
What is meant by stabilizing straps for non-trailer loads? | Non-trailer loads are hitch accessories like bike racks and cargo carriers. Basically anything that is not a trailer that you could put on a hitch. Curt recommends you use a Curt Trailer...
Installation Instructions for Wiring a 2008 Volkswagen Rabbit to Tow a Trailer
My question is about the electical hook-up. Can I splice a 4-flat connector directly into the wiring harness, or do I need some kind of powered module dure to the fact that it6 haqs LED lights? | Due to the MX (Multi-Plexed) wiring system on...
Trailer Hitch Recommendation for a 2007 Kia Rondo
I am looking for a trailer hitch for a Kia Rondo that was manufactured in Dec, 2006. I dont see one in your listing earlier than 2007. Thank You | That is because you most likely have a model year 2007 Kia Rondo that happened to be built in...
Factory Luggage Rack Capacity Buick 1996 Roadmaster Station Wagon
How much weight can the roof rack or carrier on Buick 96 station wagon Roadmaster hold with out damaging the roof? | I was lucky enough to be able to find a .pdf copy of the 1996 Buick Roadmaster Station Wagon owner's manual online. Buick states...
Trailer Hitch Recommendation for a 1994 Buick Roadmaster Estate Wagon
We have been looking for a while now to find a class III hitch for our 96 Buick Roadmaster. Would you know a class III hitch that fits? Or can be made to fit? It needs to pull a 1972 Airstream Argosy of -empty- about 3500 pounds. | We have a...
How Tight Should Compression Fitting # D13032 Be when Installing a Transmission Cooler
Hi guys! With regards to the compression fitting installation, can you please tell me how tight I should tighten the crush nut and the barb fitting. Do I need to go all the way until no thread is left? | Generally, you will tighten the fittings...
Trailer Hitch and 4-Way Wiring Recommendation for 2018 Mitsubishi Eclipse Cross
I need a hitch and 4 wire harness for a 2018 mitsubishi eclipse cross | For your 2018 Mitsubishi Eclipse Cross we have the Curt hitch # C13273 which is a confirmed fit and then for 4-way wiring you'd want the part # C56296 and you'd be set. |
Replacement Curt Trailer Hitch Hardware Kit for a 2009 Volkswagen Rabbit
Hi - I recently received a CURT C11074 Trailer hitch for the 2009 VW Rabbit from a friend who no longer has their MK5 rabbit. Is it possible to purchase *only* the replacement mounting hardware for this specific mount instead of the generic...
Is Trimming of the Foam Absorber Required for the Curt Hitch On a 2010 Mini Cooper Convertible
have a question about hitch and hard form . I removed the bumper today for preparation for hitch installation. The bumper has the hard foam but it is wedge between the front and back metal bumper with a full metal back hard foam cannot be...
Filter Your Search
Contact and Help