Result: Step Support

Here’s a practical way to decide: If you’re keeping things simple or under ~1500–2000W, stick with 12V ( # VN55ZR or # VN42VR) If you’re planning 2000W+ loads, solar, or future expansion, it’s worth stepping up to 24V ( # VN44RR or # VN58ZR) Just keep in mind - if you go 24V, you’ll need a step-down converter like # VN32ZR to run your 12V components (lights, fans, etc.) properly. |

Additional, where would it be connected, the only solenoid I am aware of is under the steps has a part number of 120-105851-6 coil 12V DC cont. | I have a 2021 Coachman Mirada RV and recently swapped to lithium batteries. I...

If I switch to a 24V battery setup, can I just tap one battery for my 12V lights or do I need a stepdown converter? | Hey Mark, you’ll definitely want the step-down converter. Tapping a single battery in a 24V bank can cause imbalance and shorten...

This converter steps your 24-volt system down to 12 volts, allowing you to safely power the Velit heater. | Can this be run on a 24 volt system? | Hi Brian, Appreciate the question and allowing us to help! Unfortunately,...

I know that seems redundant but in every diagram in the instructions that step is shown. I attached a wiring diagram for you to check out as well. | 2018 Ford F-150 SuperCrew with Max Tow package, 240W alternator. Installing...

Hey Melissa, great question - this is the one thing you always have to plan for with 24V. Your RV’s lights, fans, and most accessories still run on 12V, so you’ll need a step-down converter like # VN32ZR. ...

But for anything with a heating element, you’ll want to step up to a larger inverter like the 2,400w # VN42VR. | Can the VN55ZR run a microwave in my camper or is that too much for it? | Hey Jeff, we have a solution, but that’s...

Smaller units like the 12V 1,000W inverter # VN55ZR or 24V version # VN44RR work well for electronics and light loads, but they’ll struggle with higher-draw appliances like a microwave. Most RV microwaves pull around 1,000–1,500 watts, so stepping up to a 2,400W unit gives you the headroom you need - plus the # VN42VR also includes a built-in charger and transfer switch, which simplifies your setup. |

The tradeoff with 24V is that your RV’s 12V components (lights, fans, etc.) will need a step-down converter like # VN32ZR to run properly. | hi I'm upgrading to lithium batteries and debating if I should stay...

I already have 2 12V batteries. Is it worth rewiring them into 24V or should I just leave them in parallel and use something like VN42VR? | Hey Jason, you can go either way - it just depends on your goals. Keeping them in 12V parallel works...

If you want a little more breathing room so you’re not thinking about power management as much, stepping up to something like the Victron Quattro II # VN42VR 12V or # VN58ZR 24V gives you 2,400 watts continuous (peak of 5,500w) and a built-in transfer switch. |

I’d love to run my air conditioner off batteries when we stop for lunch or a quick break. NOT all day. Which of these Victron inverters would actually do that? | Hey Chris! It really comes down to both inverter size and battery system. The...

Both give you clean AC power without needing to tie into a full RV-style electrical system. You’d only step up to something like the 2,400w Victron Quattro II # VN42VR 12V or 2,400w # VN58ZR 24V if you want built-in charging, automatic switching between shore power and battery, and full system integration. |