Result: trailer weight scale

Yes, you are on the money with the fits. The Timbren Front Suspension Enhancement System #TFF350SD2 is a fit for the 2-wheel drive model of the 2003 Ford Excursion, while the Timbren Front Suspension Enhancement System #TFF350SD4 is a fit for the…

I didn't receive your photos, but the manner in which you attach the e-track to your trailer deck will completely depend on what the deck is constructed of and where exactly on the deck you'll be placing the e-track. Without knowing any…

Because your trailer is a straight-tongue or pole-tongue trailer, you will need a pole-tongue adapter like #RP58393. For a weight distribution system, I recommend Reese Steadi-Flex Weight Distribution with Sway Control part #RP66561. This system is…

Yes you can just swap out the bars on your Equal-i-zer Weight Distribution System w/ 4-Point Sway Control #EQ64FR with the Replacement Spring Bar for Equal-i-zer Weight Distribution Systems #EQ90-02-1499.

Each weight distribution hitch has a tongue weight capacity range where it's most effective and can help evenly distribute the weight of the trailer. If the fully loaded weight of your trailer is 8,400lbs and you keep increasing the rating of the…

The parts that are different between your 1,000 lb tongue weight rated Equal-i-zer kit part #EQ37100ET and the 1,600 lb tongue weight rated kit part #EQ64FR are just the spring bars and the head of the system. With that said the 1,600 lb tongue…

There area few differences between the 1,200 and 1,400 pound Equal-I-zer systems. The heads are different and the spring bars are different. If your tongue weight is over 1,200 pound then the 1,200 pound system is not rated high enough. When…

When it comes to picking out a 14,000 pound weight distribution system with a 2-1/2 inch shank, I recommend The Equal-i-zer Weight Distribution System w/ 4-Point Sway Control - 16,000 pounds GTW, 1,600 pounds TW #EQ64FR. This weight distribution…

It is usually possible to replace the spring bars in a weight distribution hitch setup so long as the two sets of bars are the same type, both trunnion style for instance, and both are from the same generation of hitch. A 10-year-old setup may not be…

As the repeater is just boosting the signal from the sensors to the monitor, you should still mount it on the trailer. There should be no issue at all for the sensors to connect to the monitor when mounted in the vehicle.

When we spoke with our contact at Curt they said the only time they've heard of the Curt T-Connector #C86CR having issues is when one of the pins was loose on one of the connectors. They replaced the kit for the 2023 Mazda CX-30 and everything…

I made a picture showing 3 important measurements on the Draw-Tite adjustable ball mount #7390. The distance from hitch pin hole center to ball hole center is 11-3/4 inches. If the extra 2 inches is needed in a ball mount then of course it would be…