Distance from Hitch Pin Hole Center to Ball Hole Center on Draw-Tite Adjustable Ball Mount # 7390

Updated 02/19/2020 | Published 06/05/2012

Question:

Need to know the length from the Pin Hole to the Ball Mount Hole on Part #7390. Is 14inch better than a standard 12inch of the same weight capacity?

asked by: Smitty

Expert Reply:

I made a picture showing 3 important measurements on the Draw-Tite adjustable ball mount # 7390. The distance from hitch pin hole center to ball hole center is 11-3/4 inches.

If the extra 2 inches is needed in a ball mount then of course it would be beneficial to go with the 14 inch. But in comparison of 2 ball mounts that are the same in every other way except length, there is no benefit in choosing one over the other. You may get less rattle with the shorter model and there will be a tad less stress on the hitch but the difference will not be noticed.

expert reply by: Michael H

click to enlarge

Philip W.

2/18/2020

My 2013 VW Touareg TDI owners manual states that the pinhole-to-ball distance should not exceed 6 1/8. How important is that? Is that not impossible with a sway bar setup?

Chris R.

2/19/2020

I would say that if your owner's manual calls for that max distance you should try to follow it if at all possible. It likely has to do with the extra leverage that a greater distance creates and VW isn't comfortable with the Touareg's frame safely handling this. I looked through our ball mounts and unfortunately we don't have a 2' unit with this short of a shank available.

Ask The Experts a Question >>

Video/Article/FAQ this Question was Asked From

Article or Video

Distance from Hitch Pin Hole Center to Ball Hole Center on Draw-Tite Adjustable Ball Mount # 7390

Continue Researching