Search: kwikee   >   Trailer Safety Chains   >  

If your Kwikee Steps #LC3711363 all of a sudden aren't operating correctly on a nearly brand new motorhome then my first recommendation would be to check the wiring for any damage or loose connections and then test the ground and the 12v…

When it comes to replacing the motor on your Kwikee steps I recommend The Motor Upgrade Kit for Kwikee Electric RV Steps #LC379145, This motor will fit step series 22, 23, 28A, 30, 32, 33, 34, 35, 36, 38, and 40 and your 903206001 is a 32 series.…

I won't be able to tell you off-hand what size studs you have on your 2016 Ice Castle trailer but I can help you figure out what you have. The reason I can't just tell you, even knowing it's an 8 lug hub, is because…

The towing capacity for a pickup like your 2017 Ford F-250 Diesel 4X4 depends on all of the factory equipment installed, including engine, cab style, transmission and rear differential. You are correct that a hitch may be rated for more or less…

Hopkins 7-way/4-Pole Vehicle Connector kit #HM40975 consists of the 4-and-7-way connector, a mounting bracket and hardware. No relays are included since this kit is intended for use on vehicles equipped with a factory 7-way tow package. The similar…

The correct linkage you need for the Kwikee step you mentioned is the part #LC369488. For replacement parts beyond that you'd need the part #LC369529 which is a motor, gear and table replacement.

The correct replacement step for your 28 Series Kwikee step with the part 902809025 is actually listed as part #LC3747453 on our site. If you are just needing the replacement frame for this step it is part #LC3747457 while the replacement step motor…

The replacement circuit board for your MaxxFan 4201 Series is the Replacement Printed Circuit Board and Switch for MaxxFan 4301 Series Roof Vents #MA10-04301K-V16. The 4201 series circuit boards may look different compared to the upgraded circuit…

The Replacement Printed Circuit Board and Switch for MaxxFan Roof Vents #MA10-04301K-V16 is the upgraded circuit board from what you sent in a picture of (4201). This will still work for you and will give you a more reliable board.

I reached out to Dexter and they no longer make that axle. I can confirm based on the bearing sizes you gave that you have a 3,500 lb capacity. If you determine you just want to replace the hub, I recommend the Trailer Hub and Drum Assembly for…

It does sound as if your controller is causing the issue. The correct replacement for your Kwikee 909510000 step control is Lippert part #LC379146.

The Replacement PowerGear RV Above Floor Slide-Out Motor #LC368417 is the correct motor to replace the 130-1204G you currently have.