Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
If ground clearance is your primary concern I have a great solution for you. Instead of a standard axle like the part #T3584F-EZ-8974 that you referenced you would want a Timbren Axle-Less system like the part #ASR35HDS02. This setup has the same…
view full answer...I checked directly with Dexter, and from what I saw they have a measurement - taken from center of spring eye to center of spring eye - of 24.8", which is the same as our 24-7/8" measurement for the 7-Leaf Double-Eye Spring for…
view full answer...We do offer 12 x 2-inch electric brake assemblies with a 4-bolt mounting flange. Dexter parts #23-106-09 and #23-105-09 are right- and left-hand brake assemblies that have dual mounting hole patterns, both 5-hole and 4-hole. These brakes are rated…
view full answer...Unfortunately, we do not have the 14” diameter x 2” wide braking assemblies you need for your trailer. I also did some searching online and could not find any replacement parts for you either. The only option I can offer you would be to replace…
view full answer...The mounting holes (4 hole pattern) on Dexter brake assembly, #23-106-09, are 3.09 inches on center for the top two holes and 2.55 inches apart on center for the bottom 2 holes. Top to bottom they are 3.40 inches apart on center. The holes can…
view full answer...The left side is the driver side, right side is passenger side. On a trailer brake assembly like #23-105 the arm that the magnet is on points to the front of the trailer and the magnet always will be on the bottom. I have included a picture that…
view full answer...With the 1/2 inch diameter wheel studs on your etrailer.com Idler Hub Assemblies #AKIHUB-545-35-K and the 15 inch steel wheels from the Loadstar Tire and Wheel #AM3S640DX, you are looking at a torque spec of 90-120 ft.-lbs for the lug nuts. I have…
view full answer...If your leaf springs are already located above your trailer axle then the Dexter Trailer Springs Over-Under Conversion Kit #K71-385-00 won't change anything as its designed to relocate axles from above the leaf springs to below the leaf springs.…
view full answer...We do indeed have a shroud that will fit your Dometic Duo-Therm 600315.331 air conditioner: - Replacement RV Air Conditioner Cover for Penguin and Dometic Air Conditioners #AT3308046006 The #AT3308046006 is designed specifically to fit the 600315…
view full answer...To get an AC unit that has a start capacitor you're going to want to swap out your Carrier AC for the Advent Air Replacement RV Air Conditioner for Carrier Setup w/ Start Capacitor #ACCAR135. This will fit exactly where your Carrier fits so you…
view full answer...A replacement for your 834AV21.400 model awning would be the Solera 21' Black Fade RV Awning Roller and Fabric #LCV000211531. This is the fabric and the roller, we have a few different color options. I have included a link to those options.
view full answer...The only way to know for sure the capacity of your axle is based on the information from the manufacturer when the axle is new. Typically, 1-1/2 inch square axels have a capacity somewhere between 1,000 - 2,000 pounds. Sometimes the spindle and hub…
view full answer...Related Searches
Filter Your Search