Result: mounting bracket

Hey David! The Curt Cargo Bag #C18211 can be used with the 22x60 Flint Hill Goods Cargo Carrier #FHG49ZR. However, the bag itself is 22" wide, while the cargo carrier has an inside width of 20-1/2". You will be able to sit it down inside…

In regards to the Curt Trailer Hitch Receiver part #C15302 which is a fit for a 2001 Chevrolet Silverado 2500 HD - 6-1/2 Foot Bed, there are only two factory weld nuts in the frame which get reused, they are the two closest to the bumper. The other…

With Curt Trailer Hitch Receiver #C15302 installed on a 2003 Chevy Silverado 2500 short bed the hitch will be in the same position as a factory hitch or at least within a fraction of an inch. By that I mean the receiver will be right under the rear…

Hey Mark, so the Curt hitch part #C15302 basically is strong enough without attaching to the bumper so it wasn't designed into it. Curt is very thorough with their hitch designs so I would not worry about this hitch not having the needed…

Hey Phillip. The mounting bracket item #18144 is exactly what you need for the Blue Ox Trailer Hitch item #BLU33UR. This 2" hitch is custom fit for the 2020 Jeep Wrangler Unlimited. The mounting bracket will bolt directly to it. For a wiring…

Yes, the Curt T-Connector #56407 will require you to route a power wire from the black module box to the battery on your 2024 Jeep Wrangler. I know it isn't convenient, but it's the best setup when it comes to a trailer wiring harness since…

Hey Keith. For a plug and play wiring harness that fits your 2023 Jeep Wrangler JL, you'll want the Curt T-Connector Vehicle Wiring Harness item #56407. This custom-fit T-connector plugs into your Jeep's wiring harness, which is located…

The Air Lift 1000 Air Helper Springs for Coil Springs item #AL29PD are a universal fit. I spoke with my rep at Airlift. If the rear coil springs on your 2011 VW Jetta Sport Wagon measure just over 3-1/2" in diameter and 7" in length when…

I spoke with my contact at Curt and he put together a chart that has all of the dimensions of the hitches you referenced.

I spoke with my Curt representative, who tells me that the front face of the receiver would sit 10-3/4 inches rearward of the rear-most mounting hole. If you find the rear most mounting hole in the underside of the frame member and measure 10-3/4…

I checked with Curt and the distance between the vertical mounting flanges of the Curt #C15300 is 33.312 inches.

Curt Class V hitch #C15300 is a confirmed fit on your 1987 Ford F-150. To help you determine if it will be compatible with your skid plate I went to our warehouse and took a measurement of the hitch to find out the distance from the mounting brackets…