Result: Coupler Pin

Hey Vic, I checked with Seaflo and yes their water pump part #SE24FR that you referenced is compatible with accumulator tank like what you have. What water pump do you have now?

The most likely scenario that would lead to your right tail light staying on even after it is unplugged is that somewhere along the wires running through your trailer, there is an inadvertent bare connection between your right tail light wire and the…

Hey Morgan, the best hitch for what you are looking for would be the Curt #C67JR which has the easiest install and the highest tongue weight rating. The hitch does fit right up under the rear bumper which will slightly reduce ground clearance but it…

Hey Lawrence, thanks for reaching out. The Curt T-Connector #C56040 is correct for the 2025 Subaru Forester Hybrid. The factory harness plug should be in the rear cargo area behind the driver side access panel. If you remove the trunk floor covering…

Hey Nelson, welcome back and congrats on your new SUV! We get our information directly from Curt and their item #C13409 and item #C47HR hitches fit all models of the 2025 Subaru Forester including the hybrids. This is why we don't list a hybrid…

Hi Steven; I believe there was a change in the wiring for the 2026 model that doesn't allow the previous custom wiring to cross over. I'm sure Curt is working on a new wiring harness but we don't have an ETA on when that might be…

Hey Tyler, thanks for reaching out. I'm sorry to say no, we don't have a 5 on 4-1/2" hub, or any hub for that matter that fits a 3/4" straight spindle. That kind of spindle was really only seen on older trailers and is basically…

Hello Joshua, thanks for reaching out. Yes, we do have a trailer hitch for the 2025 Subaru Forester Hybrid. We actually have two hitch options for that, and it really comes down to your customers preferences. First is the etrailer Class 3 Hitch…

Hey David, Unfortunately, Harbor Freight trailers do not use standard spindles and require a 30205 bearing with a specific 0.985" inner diameter. So, while we have bearings and hubs with similar dimensions to theirs, we do not have the exact…

Hey Larry, we have the Roadmaster Hitch Spare Tire Mount #RM-195125 that can fold down for truck tailgate access. Is this what you were thinking of?

Yes, you can use a fuse tap like the part #F2526 to tap into the stoplight circuit of the vehicle for a dedicated brake signal for installing a brake controller. Any time the brake lights are turned on this circuit would have voltage on it.

The screw and nut assembly, #BD500250, fits Bulldog jacks rated at 10,000 lb lift and 12,000 lb support. We also have kit, #BD500217, which is designed to fit Bulldog series 182 jacks from 2003 to present with a 12,000 lb capacity. I have included a…