Search: e99045   >   Roof Bike Racks   >  

I have a solution for you but you will need to supply your own pipe to get your desired 33-1/4 inch size. The Universal cam-door lock with 1 inch keeper #383200 will allow you to create a bar lock assembly of 33-1/4 inches. With this item you…

We actually have a spare wheel carrier for trailers with angle-iron rails with the etrailer Spare Tire Carrier for Trailer with Angle-Iron Railing #e99045.

The Fulton Economy Spare Tire Carrier with Wheel Nut Lock #FETCSTL0701 would work just fine on a section of angle iron that is 3 inches by 2 inches. The frame does not have to completely fill out the U-bolt to allow the carrier to install. I…

You'll need to start by having a new hanger welded on since it looks like the hanger towards the front of the trailer has been broken off. Once that's welded in place you can then install a new leaf spring. To determine the correct…

My contact at Dexter was able to use your Dexter Axle number 4389878 and Serial number 125263858 to find the bearings. She said your hub uses outer bearing 031-030-02, outer race 031-030-01, Inner bearing 031-019-02 and Inner race 031-019-01. These…

I attached the chart you referenced and it states that when you use a #e54SR spring with a hanger kit part #APS3 the hanger distance should be 24-7/8 inches. The length of a spring when new and not installed on a trailer will be slightly shorter than…

When choosing between the Single-Axle Trailer Hanger Kit for Double-Eye Springs part #APS1, part #APS2, and part #APS3 it will be best to use the one that has measurements that most closely resemble what is already on your trailer. For example, if…

Bushings do not always have to be used. Springs typically have bushings or they will use wet bolts depending on which part of the suspension system it is but not always. The bushings limit the wear on the suspension components. There are just…

I went out to the warehouse and pulled hanger kit #APS1 to measure the hangers for you. The larger hangers measure 3 inches long, 2-5/16 inches wide, and 2-1/8 inches tall overall. The smaller hangers are 2-1/8 inches long, 1-13/16 inches wide, and…

The APS1, APS2, and APS3 are all suspension kits for single-axle trailers with 1-3/4-inch double-eye springs. They are designed for use on trailers with single, 2,000-lb to 7,000-lb axles. The difference in the kits are in the rear hangers and the…

The trailer wheel part #AM32575 that you referenced is designed to be used with acorn lug nuts and not ball style. The part #KALN1375S would work great as this is the correct size, taper, and since it's a solid stainless steel lug nut you…

Thank you for all of the info! I'd be more than happy to help out. For an axle that meets your specs I recommend going with our etrailer Trailer Axle #e37YR which has the 58" spring-center measurement, a 72" hub-face measurement, has an…