Search: circuit breakers > RV Light Fixtures >
Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
In the question and answer page you're referring to Kyle states that the Replacement Converter for Parallax/Magnetek or WFCO RV Power Centers - 35 Amp #PD4635V could be used in to replace the converter section, but that it was only intended for…
view full answer...The first thing you'll need is a power inlet to receive power from the shore power pedestal. You'll most likely only need 30amp service since you're in an enclosed trailer so I recommend the Hughes Autoformers Safe View Smart Power Inlet…
view full answer...The Camco Water Heater Element #CAM02143 is what you need for the SW6DEL water heater. According to our research this element will replace the heating element perfectly in your Suburban water heater. You can also use the Camco RV Water Heater Anode…
view full answer...Hello Mike, I am curious on what kind of batteries you are trying to charge, if they are Lithium batteries that would explain why it is not working. If you have lead-acid batteries (flooded or AGM) I would just swap out the converter section with the…
view full answer...For the absolutely best performance and reliability you can't beat the HydraStar electric over hydraulic actuators. We have found that they are the most reliable, react the fastest and just in general work the best. For just the actuator you…
view full answer...It does sound like there is an internal problem with the Dexter actuator. There are no user serviceable parts on the inside so the only solution would be to send it in to Dexter to be repaired or purchase a new actuator. If you decide to go with a…
view full answer...You will want to start by following the troubleshooting tips in the manual for the electric over hydraulic actuator, #K71-651. I have outlined them here for you: 1. Verify that the trailer and tow vehicle are wired according to the electrical…
view full answer...For the Progressive Dynamics converter #PD64FR that you referenced on the DC side you would need to use the 2 or 0 gauge wire otherwise you would most likely see an error code.
view full answer...The American CS6000XL that you referenced is no longer available and there isn't a direct replacement for it but the closest solution as a replacement would be the Progressive Dynamics RV Control Center part #PD4560K18LS8 which as the same…
view full answer...Yes, you can use a 3000w Inverter with transfer switch like part #34275013 and still use it with your Progressive Dynamics Mighty Mini AC/DC Panel and Converter/Smart Charger #PD4060K. The inverter is going to require you to have two separate AC bus…
view full answer...Yes, in order to set your trailer up for use with shore power you will first need an AC distribution panel. For this, I recommend a Progressive Dynamics Series AC Distribution Panel. In order to bring power into the panel you will also need a power…
view full answer...To replace your Iota IDP-240 you'll want to use the Progressive Dynamics RV Power Control Center with AC/DC Panel and Converter/Smart Charger #PD4560K18LS8. This panel is rated for 50 amp service, can provide both 120v/240v and is compatible with…
view full answer...Filters
- 28 results
Vehicle Fit
Filters
