Search: 45050   >   Floor Mats   >  

I Recommend the etrailer Trailer Hitch Receiver #e48AR for your 2020 Jeep Compass. The Receiver #75699 is a custom fit on certain model year Jeep Grand Cherokees. Our Receiver #e48AR has a hidden cross tube and a matte black finish to give it a…

The Ram Trailer Jacks generally use a 1" diameter threaded rod whereas the Bulldog Trailer Jacks generally use a 1-1/4" threaded rod. Therefore, it would appear as if you have a Bulldog Trailer Jack and in which case the Replacement…

The 7,200 lb Dexter hub is the part #8-393-4UC3 which takes the grease seal part #10-63.

The 10 to 18 inch measurement is referring to the wheel/rim only - not the whole tire - for the Trimax wheel lock, which is the following part number: - Trimax Heavy Duty Adjustable Wheel Lock with Padlock - 10" to 18" Wheels…

I have a solution for you but there isn't just a replacement converter section for the Elixir ELX-45. You're going to need to replace the entire panel with the Progressive Dynamics Mighty Mini AC/DC Panel and Converter/Smart Charger…

The Adapter 6-Pole to 7-Pole Trailer Wiring Adapter #47435 will plug into a 6 round connector on your truck and then convert it to the larger more common 7-pole connector. While the connector is round the terminals inside are mostly blade…

If you are looking for a temporary solution the Trailer Connector Adapter #HM47425 is the simplest solution. You can plug it into your International dump truck and have the 7-way blade connector available. If you are looking to add a more permanent…

An ST205/75R15 tire size like you have now will have a section width of 8.1 inches and overall diameter of 27.3 inches. An ST225/75R15, #AM10256, will have a section width of 8.9 inches and overall diameter of 28.4 inches. So the larger size is 0.8…

I spoke to Dexter and they said there is a bit of a process for installing the spindle nut properly. 1. You will need to thread on the inner nut, rotate the hub, then tighten the nut to 100 foot pounds. 2. Loosen the nut to remove the torque,…

The Lippert 2" Trailer Hitch Receiver part #LC730647 is specific to Vanleigh 5th Wheel Trailers. If you take a look at the attached photo you will see that there are tabs on this trailer that sit below the frame and the trailer hitch…

I checked with Lippert and the part number you mentioned corresponds with the Revolution Kwikee step and the replacement control module you need then is the part #LC363985.

The only bolt-on swivel jack we have that works with 6" tall trailer frames is the Trailer Valet 5X Swivel Jack and Trailer Mover part #STC-V211. The Trailer Valet has a 500 lb tongue weight capacity and works with frame rails up to…