Looking For Hubs For 1.25" Straight Spindle On 1941 Power Company Trailer
Hello. I just purchased a trailer for a build i am doing and the hubs are built into the rims which is cool but makes it tough for having a spare. Its a 1941 power company trailer. I would like to run an 8 lug hub my only issue i am finding...
Thule Spare Me Rack on 2010 Rav4 with Back Up Camera
I see that I cannot use a Thule Spare Me 2 bike carrier if I have a backup camera on my 2010 Rav4. Why? What are the alternatives? I can live without the camera for a short term. Thanks! | I spoke with the folks at Thule regarding the spare...
Trailer Hitch and Wiring for 2009 Mercedes R320 Diesel
I have a 2009 mb R320 diesel w251 . The information on the web site indicates the class 2 trailer hitch and separate wiring packages are for a r350 MB the wiring package is with brake controller and 7 way. Can to clarify the correct products...
Diagram of the Portion of the Fascia that Needs Trimmed to Install Curt Hitch # C13103
do you have a sketch of how much to trim do you cut around hitch support bar ? | I attached a copy of the installation instructions for the Curt hitch # C13103 which is confirmed your 2007 Mercedes R350. The installation instructions have...
Should Radial or Bias Tires be Used for a 3500lb GVWR Pop Up Camper Trailer
Vehicle - 2011 Coleman Sun Valley pop up camper. Fully loaded - 3500lbs I cant seem to figure out which tire to get. It seems there is much debate on trailer tires, whether to get radials or bias ply. My stock tires are Kenda ST185/80D13-D and...
Replacement Jack For 2001 Stratos Bass Boat Trailer
I have a 2001 Stratos Bass boat with a Fulton center bolt swivel jack onto a welded plate on the trailer. I would like to upgrade to the Fulton F2. My holes on the plate are 3X3 on center. Will the F2 work? Can I send you picture? Thank You...
Installation Instructions for Wiring a 2008 Volkswagen Rabbit to Tow a Trailer
My question is about the electical hook-up. Can I splice a 4-flat connector directly into the wiring harness, or do I need some kind of powered module dure to the fact that it6 haqs LED lights? | Due to the MX (Multi-Plexed) wiring system on...
Why is a Stabilizing Strap Recommended on Curt Hitches and what is Meant by Non-Trailer Load
What is meant by stabilizing straps for non-trailer loads? | Non-trailer loads are hitch accessories like bike racks and cargo carriers. Basically anything that is not a trailer that you could put on a hitch. Curt recommends you use a Curt Trailer...
What is the Battery Life for Hopkins Wireless Magnetic Tow Lights
What is range of battery life for these lights? The check battery level indicator light every 2 hours statement has me concerned. I drive for much longer stretches than that and dont wish to carry excessive spare AAs or replace them every couple...
Recommended Weight Distribution System For Prolite S Camping Trailer
Hi, my Prolite S camping trailer is @ 1600lb heavy, tongue weight is 200lb, what weight distribution you can recommended for me?? Plese ASAP. Thanks | For your Prolite S camping trailer, I recommend the Reese Steadi-Flex Weight Distribution...
Does The GE Appliances RV Refrigerator GE58FR Come With A Mounting Bracket?
Does this with mounting brackets? | Hello Raymond, thanks for reaching out. The mounting brackets are not included with the GE Appliances RV Refrigerator # GE58FR. It requires a GE approved top bracket part BMT-GPV10. This is not something we...
Is Cutiing Required for Installation of the Mercedes-Benz R350 Trailer Hitch # C13103
I would like to know if there is any cutting of the oem bumper required in order to fit your trailer hitches? | You will not need to cut the OEM bumper for installation of the Curt Trailer Hitch, item # C13103, for the 2008 R350 by Mercedes-Benz....
Trailer Hitch for a 2012 Mercedes R350 BlueTec
Will this hitch also fit the Mercedes 2012 R350 Blue Tech diesel model? Also, where is the best place to get the hitch installed once I buy it? I doubt that a dealer would do the work but I am afraid to trust non-Mercedes technicians, especially...
What is the Weight of Hollywood Racks Sport Rider SE2 2-Bike Platform Rack # HR1450Z
How much does this bike rack weigh? We plan to use it with two different vehicles and ease of moving from one to another is important. We had the Thule Apex and it weighed 41#s which was OK. Does this weigh about the same? | The Hollywood...
Removal of Fascia on Mercedes 2008 R350 When Installing a Curt Trailer Hitch, Part # C13103
Once I get the facia off, I can install the hitch. Any tips? Ive removed the 4 bolts under the rear bumper. How do I get the rest of the facia off? CURT 13103 model hitch. | I spoke with my contact at Curt and he informed me that the underbody...
Availability of Hitch for 2006 Mercedes R500
Does this fit a 2006 Mercedes R500? | We offer two different Class III hitches that are a fit for your 2006 M/B R500. Both the Curt # C13103 and the Draw-Tite # 75470 offer a 3500 lb towing/ 350 lb tongue weight capacity, but the warranty requirements...
Will the Thule Pulse XL Roof Cargo Box Fit on the Factory Crossbars on a 2011 Mercedes R350
Hi, I am planning to purchase the Mercedes Benz Basic Roof Rackinch for my 2011 R350. I would like a roof cargo carrier that will work with the Mercedes Benz rack. Will this box fit on the MB Basic Roof Rack?inch The MB Roof Rack has a channel...
Ground Clearance of Curt Hitch Installed on 2008 Mercedes Benz R320 CDI
Is the car just too low for a hitch? | For your 2008 Mercedes Benz R320 CDI we have the Curt hitch part # C13103 as a confirmed fit. This will fit your vehicle will and will not sit too low at all. When we installed this hitch on a similar 2006...
How Much Does the Thule Hitching Post Pro Bike Rack Weigh
I am wondering how heavy the bike rack is before I order it. thanks - | The Thule Hitching Post Pro # TH934XTR has a shipping weight of 41 pounds. The rack itself, minus the packaging, weighs about 38 pounds. I have linked a video review of...
Wiring Kit Compatible with 2011 Mercedes-Benz R-Class
Hi, I reviewed questions and eTrailer expert answers related to an R class hitch installation. The thread below caused a bit of confusion: https://www.etrailer.com/question-117319.html. My 2011 should be electrically the same as the 2012 model...
How to Tell if the Yakima SkyBox NX 16 Will Fit a 2006 Toyota RAV4
Will this box fit my 2006 Rav-4? It has a factory rack and cross bars. | Here is how you can determine if the Yakima SkyBox NX 16 Rooftop Cargo Box, # Y95AV, will fit your 2006 Toyota RAV4 and allow your rear hatch to open. Measure the crossbar...
How to Determine Which Replacement Axle is Needed for 1979 Avion Travel Trailer
I HAVE A 1979 AVION TRAVEL TRALER WITH 4 SEPERATE AXELS. THE SPINDEL IS BENT ON THE RIGHT FRONT AXEL, THEREFOR WEARING MY TIRE DOWN WITHIN 3,000 MILES. DO YOU HAVE ANY IDEA WERE I MIGHT PURCHASE AN AXEL? THANK YOU | In order to determine which...
Is Trimming of the Foam Absorber Required for the Curt Hitch On a 2010 Mini Cooper Convertible
have a question about hitch and hard form . I removed the bumper today for preparation for hitch installation. The bumper has the hard foam but it is wedge between the front and back metal bumper with a full metal back hard foam cannot be...
Can a 4-Bike Platform Bike Rack be Used on a 1-1/4 Inch Trailer Hitch on a 2011 Mercedes R350
I have a 2011 Mercedes R350 with a 1-1/4 inch hitch. the label on the OEM hitch states that the car has a 280 pound tongue weight. Can I use the Yakima holdup 2 rack with 1-1/4 inch hitch and add to it the Yakima holdup +2 2 bike add on? ...
Filter Your Search
Contact and Help