Result: Spring bars

In this case, it doesn't sound like the spring bars need to be swapped out. Although I don't know the exact model of your camper, the tongue weight is going to be 10-15% of the loaded weight of your Wolf Pup....

We don't carry the EAZ brand so we aren't able to get the replacement spring bars you are looking for. | I have an Eaz-Lift Elite weight distributing hitch that I use with my Airstream 19CB trailer. I bought...

The risk of going to a higher than needed spring bar is not that it will bend the trailer frame so much as it is that the ride quality would become harsher. | Question about upgrading Fastway E2 round bars...

Will the Replacement Trunnion Spring Bar for Curt TruTrack Weight Distribution System - 800 lbs TW,Item C17535 fit the Curt 17520? | 2005 Ford Excursion, towing a 3500-4500 lb single axle travel trailer with...

If you don't have the coil springs then you have a torsion bar. Attached is a link to our fit guide for your Ford Ranger. | Would my 2002 Ford Ranger xl 2wheel drive have torsion bar on it or coils | I am...

However, a really easy to install and helpful suspension enhancement for your Ranger that I recommend is the SumoSprings Solo Custom Helper Springs - Rear Axle # SS86MR. | what roadmaster rear swaybar work...

You will end up needing to use slightly less spring bar tension to compensate for fact you now basically have stiffer suspension. | I have a Blue Ox Sway Pro WDH. With the trailer connected, my 2021 Ford Ranger...

If you need to turn and backup it is recommend to unhook the spring bars. | looking at item C17050 for a 2021 Ford Ranger, does this system allow for backing up? Will be pulling a 4,300 trailer | The Curt MV...

A system like the TrackPro uses a spring bar design to flex more naturally instead of acting like a stiff lever. | Will be towing a jay feather micro 199mbs with a 2025 Ford Ranger with tow package. Would you...

Can I just replace the spring bars for a heavier trailer? | I have a Fastway E2 trunnion WDH rated for 450 pound tongue weight. Can I just replace the spring bars for a heavier trailer? | You are going to need...

What do I need to tow a ford ranger with adjustable tow bars with a expedition 2003 ranger 2001 2 wheel drive | What do I need to tow a ford ranger with adjustable tow bars with a expedition 2003 ranger 2001 2 wheel drive |...

In this case you can either move the jack back or even move it to the inside of the frame channel to avoid interference with the spring bars. I have attached a couple short video demonstrations on this system that you can check out as well. |

Hey Ray, while there certainly is a lot of appeal to the Andersen WD systems like the part # AN88VR what we have found is that if the tongue weight is more than a few hundred lbs they just don't work as well as the traditional systems that use spring bars instead. So if you wanted something simpler that would work a lot better I would go with a Fastway part # FA92-00-0800 instead. |

This makes them a lot more adaptable and as they do not have a bar going across the frame, you will have independent suspension. | Hello, I am fabrication a trailer that is 60 inches wide. Its a 5x10. I am planning on mounting...

This weight distribution system is rated for use for 750 to 1000 pounds of tongue weight, and is not compatible on trailers that use surge brakes. This system uses spring-bars that are adjusted by changing the number of chains used on the lift brackets. |