Recommended Tire Chains for a 2023 Rivian RS1 275/50 R22
Hello, I’m looking for low profile 16mm or smaller snow chains/cables for my 2023 Rivian RS1 275/50 R22. Would these work? Thanks! | Hey Julie, thanks for the information and the picture! I checked with Rivian and we've only got one set of tire...
Trailer Hitch Recommendation for 2002 Pontiac Firebird
Do you have trailer hitch for 2002 Pontiac Firebird. | Yes, the Curt hitch part # C11117 is a confirmed fit for your 2002 Pontiac Firebird and would work well for you. For trailer wiring you'd want the universal style kit part # 119178KIT which...
Which Kat's Block Heater Fits 2025 Mitsubishi Outlander SE 2.5 Liter
Will this heater work, without modification, on my 2025 Mitsubishi Outlander SE? Please confirm the location for this vehicle as well. | Hey James, yes the Kat's Heater part # KH11812 that you referenced is a confirmed fit for your 2025 Mitsubishi...
Would Thule Hullavator Work With Rivian R1S OEM Roof Rack?
Im trying to install the Thule Hullavator on a Rivian R1S. I already have the Rivian Cargo Crossbars so Id prefer to use these if possible. The Hullavator requires the crossbars to overhang and the Rivian Crossbars dont. Is there a way to stackinch...
Where Do You Measure From On The Trailers Coupler to Install The Pole-Tongue Adapter # EQ95-01-5950?
For the tongue pole adaptor, you mention in the video that it need to be install between 27 to 32 inches from the reveiver in the tongue. Do we mesure from the tip of the receiver or the middle, because if I mesure from the tip of the receiver...
Why Choose a Powered Taillight Converter Over a Non-Powered Model
What dictates the need between using a powered Tail light convertor Vs a non powered? | There's a couple of factors that determine that. On older vehicles, very few vehicles needed a powered converter, because the vehicle's electrical system...
Is There a Power Option For The Conventional Ramp Door Spring # CB250D96SHD?
Good afternoon, Im in the process of up grading my car hauler trailer an wondered if you guys had any info on adding a power option to your ligt gate spring assembly. My door I believe will be inexces of possiblly 500lbs Thanks in advance,...
Will etrailer Spare Carrier # e98ZR Work with Rivian R1S 20
Does this fit a rivian r1s 20 inch all terrain tire? 275 / 65 / R20 | Hey John, yes the etrailer spare tire mount part # e98ZR that you referenced will work with the wheel and tire Rivian R1S 20 inch all terrain tire that you referenced. |
How to Tell if Power Mountain Tallboy Off-Road Bottle Jack Will Work with a 2023 Rivian R1S
what jack can you recommend for changing tires on my Rivian R1S 2023 and Intech Sol Dusk Rover off road package travel trailer? Will the Tallboy pm34fr work with a Rivian puck? | Hey Darin, thanks for reaching out! The Power Mountain Tallboy...
Trailer Hitch and Wiring for a 1972 Pontiac Firebird
need trailer hitch complete kit for 1972 pontiac firebird. anything available? | Michael, there are things available for your 72' Firebird but none of it is custom. For a trailer hitch you can use the Adjustable Width Trailer Hitch Receiver...
Will the Curt Trailer Hitch Part # C11117 fit a 1984 Pontiac Firebird with Dual Exhaust
My car has dual exhaust. Will this hitch fit? | I spoke to my contact at Curt Manufacturing and they stated that as long as the dual exhaust you have on your 1984 Pontiac Firebird was installed from the factory, then yes the Curt Trailer Hitch...
Does The GE Appliances RV Refrigerator GE58FR Come With A Mounting Bracket?
Does this with mounting brackets? | Hello Raymond, thanks for reaching out. The mounting brackets are not included with the GE Appliances RV Refrigerator # GE58FR. It requires a GE approved top bracket part BMT-GPV10. This is not something we...
Replacement Jack For 2001 Stratos Bass Boat Trailer
I have a 2001 Stratos Bass boat with a Fulton center bolt swivel jack onto a welded plate on the trailer. I would like to upgrade to the Fulton F2. My holes on the plate are 3X3 on center. Will the F2 work? Can I send you picture? Thank You...
What is the Battery Life for Hopkins Wireless Magnetic Tow Lights
What is range of battery life for these lights? The check battery level indicator light every 2 hours statement has me concerned. I drive for much longer stretches than that and dont wish to carry excessive spare AAs or replace them every couple...
Installation Instructions for Wiring a 2008 Volkswagen Rabbit to Tow a Trailer
My question is about the electical hook-up. Can I splice a 4-flat connector directly into the wiring harness, or do I need some kind of powered module dure to the fact that it6 haqs LED lights? | Due to the MX (Multi-Plexed) wiring system on...
Why is a Stabilizing Strap Recommended on Curt Hitches and what is Meant by Non-Trailer Load
What is meant by stabilizing straps for non-trailer loads? | Non-trailer loads are hitch accessories like bike racks and cargo carriers. Basically anything that is not a trailer that you could put on a hitch. Curt recommends you use a Curt Trailer...
How to Choose the Correct Electric Winch for a Small Car Trailer
Need to know if a 2-ton electrical winch will winch a car up on a trailer | Choosing the correct electric trailer winch for your needs is a bit of a tricky task. The weight capacity of a winch will be affected by many factors such as the weight...
Is Trimming of the Foam Absorber Required for the Curt Hitch On a 2010 Mini Cooper Convertible
have a question about hitch and hard form . I removed the bumper today for preparation for hitch installation. The bumper has the hard foam but it is wedge between the front and back metal bumper with a full metal back hard foam cannot be...
Trailer Hitch and 4-Way Wiring Recommendation for 2018 Mitsubishi Eclipse Cross
I need a hitch and 4 wire harness for a 2018 mitsubishi eclipse cross | For your 2018 Mitsubishi Eclipse Cross we have the Curt hitch # C13273 which is a confirmed fit and then for 4-way wiring you'd want the part # C56296 and you'd be set. |
Replacement Curt Trailer Hitch Hardware Kit for a 2009 Volkswagen Rabbit
Hi - I recently received a CURT C11074 Trailer hitch for the 2009 VW Rabbit from a friend who no longer has their MK5 rabbit. Is it possible to purchase *only* the replacement mounting hardware for this specific mount instead of the generic...
Trailer Hitch Fit for 1998 Pontiac Trans Am
Says it fits 1998 firebird, how about trans am? | The Curt Class I Trailer Hitch Receiver # C11117 that you referenced is confirmed to fit both the 1998 Pontiac Firebird and Trans Am. I confirmed the fit of the hitch on a 1998 Trans Am with...
Replacement Fan Blade for 1979 Pontiac Trans Am For Clutch Application
Can this fan be used on a fan clutch in a 1979 Pontiac Trans Am olds 403 v-8? | The Derale fan part # D17418 that you referenced was not designed to attach to a fan clutch. For a similar size fan that is and the correct direction for your 1979...
How to Prevent Exhaust Components from Contacting the Trailer Hitch
I purchased the replacement CURT trailer hitch hardware from eTrailer for this hitch and installed the 11074 on my 2009 4DR Rabbit. However - after install, I now experience a lot more noise at low RPMs. Theres vibration being transmitted back...
Troubleshooting Turn and Brake Lights not Working with Running Lights on, 2009 Volkswagen Rabbit
I have the same problem than the VW GTI guy. After I have wired the kit according to the 2-wire method into my 2009 Rabbit, turn and stop light are working as long as the running light is not on. I have tried also the different 3-wire methods...
Filter Your Search
Contact and Help