Bike Rack Recommendation for 2008 Infiniti G35 that Allows Rear Trunk Lid to Open
Hi, currently looking for a trunk mount for max 2 MTB Orbea Oiz on a 2008 Infiniti G35x. Ideally one that can stay on and allows trunk to open. Do you work with shops in the DMV area that install these? Thanks | Hey Kenneth, there isn't a trunk...
Replacement Control Panel for Lippert Leveling System with Module 175226
What touch panel will work with Lippert leveling control 175226/12656 ? | If you have the module part # LC175226 the correct replacement touch panel would be the # LC421484. |
Availability of an A-Frame Coupler that is 45 Degrees and Not 50 Degrees
Is there an A frame coupler that is NOT a 50* angle? I have an older stock trailer and it needs like a 45*. | All of the A-frame couplers we carry are for the standard 50 degree A-frames. What you could do, since your A-frame is a lower angle,...
Is Trailer Suspension U-Bolt Plate Supposed to Bend and What is Torque Spec for 3/8" U-Bolts
So, I noticed in the video the spring plate does bend when tightened. How much torque was used? This is normal on the spring plates? They should bend slightly? I freaked out after I noticed my bent. But this is how it should be? | Trailer...
Does The GE Appliances RV Refrigerator GE58FR Come With A Mounting Bracket?
Does this with mounting brackets? | Hello Raymond, thanks for reaching out. The mounting brackets are not included with the GE Appliances RV Refrigerator # GE58FR. It requires a GE approved top bracket part BMT-GPV10. This is not something we...
Does the UFP A-60 Surge Brake Actuator Require Lubrication on Inner Slide Member
Does the ufp a60 actuator need any lubrication on any of the of the moving parts on the inner slide? | I looked up the manual online for the UFP A-60 Surge Brake Actuator and found the following bullet points for greasing. "Lightly grease rear...
Replacement Jack For 2001 Stratos Bass Boat Trailer
I have a 2001 Stratos Bass boat with a Fulton center bolt swivel jack onto a welded plate on the trailer. I would like to upgrade to the Fulton F2. My holes on the plate are 3X3 on center. Will the F2 work? Can I send you picture? Thank You...
What is the Battery Life for Hopkins Wireless Magnetic Tow Lights
What is range of battery life for these lights? The check battery level indicator light every 2 hours statement has me concerned. I drive for much longer stretches than that and dont wish to carry excessive spare AAs or replace them every couple...
Installation Instructions for Wiring a 2008 Volkswagen Rabbit to Tow a Trailer
My question is about the electical hook-up. Can I splice a 4-flat connector directly into the wiring harness, or do I need some kind of powered module dure to the fact that it6 haqs LED lights? | Due to the MX (Multi-Plexed) wiring system on...
Why is a Stabilizing Strap Recommended on Curt Hitches and what is Meant by Non-Trailer Load
What is meant by stabilizing straps for non-trailer loads? | Non-trailer loads are hitch accessories like bike racks and cargo carriers. Basically anything that is not a trailer that you could put on a hitch. Curt recommends you use a Curt Trailer...
Difficulty Hooking on Bottom Trunk Mount Bike Rack Straps to Truck or Hatch
Hello, my trunk is so tight there is not enough space for the hooks to fit at the bottom of the trunk lid for my 2007 Infinity G35. Attaching these hooks under the bumper is not an option because it is very soft and will pucker the bumper. I...
How to Correct Sagging Class I Hitch and Bike Rack on 2006 Infiniti G35 Coupe
Wondering if it is possible to have someone weld a higher class hitch to the frame on Infinity G35 coupe? Is this possible? Have a class I now and it is sagging badly Thanks! | Trailer hitch makers generally produce hitches that are designed...
Replacement Curt Trailer Hitch Hardware Kit for a 2009 Volkswagen Rabbit
Hi - I recently received a CURT C11074 Trailer hitch for the 2009 VW Rabbit from a friend who no longer has their MK5 rabbit. Is it possible to purchase *only* the replacement mounting hardware for this specific mount instead of the generic...
Is Trimming of the Foam Absorber Required for the Curt Hitch On a 2010 Mini Cooper Convertible
have a question about hitch and hard form . I removed the bumper today for preparation for hitch installation. The bumper has the hard foam but it is wedge between the front and back metal bumper with a full metal back hard foam cannot be...
Highest BTU Rating Available for Camco Olympian Wave Heater
Hi, I would like to know if the CAM57351 heater is CSA Canadian Standard Association approved. Also, do you have another propane heater option with higher BTU? I am looking for a 10,000 to 12,000 BTU heater. Thanks, | The highest BTU rated...
What is the Pin Diameter of 4-Leaf Double-Eye Spring for 4,000-lb Trailer Axles - 26" Dacromet
What is pin diameter on e48sr leaf spring? | The 4-Leaf Double-Eye Spring for 4,000-lb Trailer Axles part # e48SR is designed for a 9/16" diameter bolt like the Zinc Shackle Bolt with Locknut part # TRFA73Z916DLNZ. If you were to remove the...
Troubleshooting Turn and Brake Lights not Working with Running Lights on, 2009 Volkswagen Rabbit
I have the same problem than the VW GTI guy. After I have wired the kit according to the 2-wire method into my 2009 Rabbit, turn and stop light are working as long as the running light is not on. I have tried also the different 3-wire methods...
How to Prevent Exhaust Components from Contacting the Trailer Hitch
I purchased the replacement CURT trailer hitch hardware from eTrailer for this hitch and installed the 11074 on my 2009 4DR Rabbit. However - after install, I now experience a lot more noise at low RPMs. Theres vibration being transmitted back...
Trailer Hitch and Ball Recommendation for 2005 Infiniti G35 Sedan
Hi i wanted to know I have a 2005 infiniti g35 sedan and I bought a small boat and i wanted to know what hitch do you guys recommend, and if you guys have 7/8 ball size. thanks | We do have the Curt hitch part # C11482 which you referenced that...
Installation Details for Installing the Curt Trailer Hitch, # 247482 on a 2005 Infiniti G35
have you guys done an install of this hitch on any of the 03-06 sedans? I heard the fishing part is a pain. thanks! | We have a couple of videos featuring an Infiniti G35 but no hitch installations. Fish Wiring can be a little cumbersome,...
Replacement Exterior Folding Handrail for 2015 Grand Design 385TH Toy Hauler
we have a 2015 grand design momentum 385th toy hauler. will this fit where the one that is on there now looking at just taking it off and replaceing it with yours? it looks the same as ours, yours is just larger. It is mounted on the left...
Compatible Trailer Hitch Receiver to Fit 2003 Infiniti G35 M6 Coupe
I just want to know if a trailer hitch is avalaible for my g35 2003 M6. | The Curt # C11483 is designed to fit your 2003 Infiniti G35 coupe. There is some drilling and fascia trimming to install it but all the necessary hardware is included....
Winch Mount Recommendation for 2013 Polaris RZR-4 XP 900
What winch mount will work for my 2013 rzr xp 4 900? | We have the Bulldog Winch Mount part # BDW15167 which is a confirmed fit for your 2013 Polaris RXR-4 XP 900. You could use it with the part # BDW15001. |
Aero Bar Rhino Rack Roof Rack that Fits 2009 Volkswagen Rabbit 5 Door Hatch
Hello, I am looking at RR56RR for my 2009 Volkswagen Rabbit 3 door. Your site says it will fit but when I use the part number RV0230B into rhino racks site it states its only for the 5 door car. Which is correct? I really want these for my...
Filter Your Search
Contact and Help