bing tracking image

RX350  x   >   Rodeo  x   >   RVR  x   >   Venture  x   >  

Will a 4.80-8 Trailer Tire Fit in Place of a 4.00-8 Tire

I have seed planter with implement tires of 4.00 x 8. Will a 4.80 tire fit? | Yes, a 4.80-8 tire will fit in place of a 4.00-8 tire. That is why a lot of times you will see both sizes in the product's title or description and even on the actual...

Why Choose a Powered Taillight Converter Over a Non-Powered Model

What dictates the need between using a powered Tail light convertor Vs a non powered? | There's a couple of factors that determine that. On older vehicles, very few vehicles needed a powered converter, because the vehicle's electrical system...

Replacement Motor for Lippert Kwikee 32 Series Steps on 1997 Winnebago

what is the step gear and motor replacement for a 1997 Winnebago adventurer 32 | Although I managed to find an online owner's manual for your 1997 Winnebago Adventurer, it did not specify the specific steps that you have. The Winnebago manual...

Which Kat's Block Heater Fits 2025 Mitsubishi Outlander SE 2.5 Liter

Will this heater work, without modification, on my 2025 Mitsubishi Outlander SE? Please confirm the location for this vehicle as well. | Hey James, yes the Kat's Heater part # KH11812 that you referenced is a confirmed fit for your 2025 Mitsubishi...

Troubleshooting Trailer Wiring When Connecting a 4 Flat Vehicle Side to 4 Flat-5 Wire Trailer

I have a 2001 Isuzu Rodeo and was recently trying to connect the connector wires to my trailer. My Rodeo is setup to use a 4 flat female end that runs to 4 wires Ground, Tail, L Turn, R Turn to a converter that connects the 4 wires of the end...

Can a 3-Wire to 2-Wire Trailer Wiring Harness Converter be Bypassed

can i by-pass a 3 to 2 wire taillight converter in any way | The only way to bypass a 3-wire to 2-wire trailer wiring harness converter (assuming your vehicle has a 3-wire or separate tail light system) would be to convert your trailer to a...

Leaf Spring Recommendation for a Trailer to Stiffen Up Suspension that has 3,500 lb Axles

I have a boat trailer with a single 3500 LBS axle. It has the factory 3 leaf springs. With the boat on the trailer, the trailer seems to nearly bottom out on some highways. The load in the boat should not be considered overloaded. Would going...

Where is Connector Found on 2001 Isuzu Rodeo for Installing Hopkins Trailer Wiring Kit HM43215

I cannot see the plug you guys talk about in the jack compartment, however there is a similar plug on the bottom beside the spare tire is that the correct plug, and do I have to do any other connections? | The plug you have found is the correct...

Items Needed to Tow a Trailer with a 2011 Lexus RX350 Without Tow Package

I bought a 2011 RX350 Canadian version that was not ordered with the tow package. What do I need to install to properly tow our 2500 lb boat? | To tow your boat trailer with your 2011 Lexus RX350, you will need a trailer hitch, wiring harness,...

4-Way Trailer Wiring Recommendation for 2002 Isuzu Rodeo

HI first Id like to thank you for you time to answer my question. Ok I have a 2002 Isuzu Rodeo and I want to install a 4way trailer conception. But I only see a connecter with 2 wires one hot and on ground I believe they are the running lights...

4 Pole Trailer Connector on a 2004 Chevy Venture

I installed a hitch and reese wiring kit on my 04 Chevy Venture. The wiring instructions are not great. Not much help in the steps to removing the interior trim, and mine has rear air which is not mentioned in the instructions. What do I do...

Can Second Axle be Added to Enclosed Snowmobile Trailer

I have an 8x12 hybrid enclosed snowmobile trailer with a single 3500lb idler axle. I’d like to add a second axle forward of the one it comes with. Can I safely add another axle? How do I determine the optimal placement? Will a second axle...

Trailer hitch for a 2004 Isuzu Rodeo with 3.5 Liter Engine

my is 2004 rodeo 3.5 liters wish i will use | The only trailer hitch that will fit the 2004 Isuzu Rodeo with 3.5 liter motor is Curt hitch # C13235. But in order for this hitch to fit your Rodeo must have the rear door mounted spare tire. It...

Trailer Hitch and 4-Way Wiring Recommendation for 2018 Mitsubishi Eclipse Cross

I need a hitch and 4 wire harness for a 2018 mitsubishi eclipse cross | For your 2018 Mitsubishi Eclipse Cross we have the Curt hitch # C13273 which is a confirmed fit and then for 4-way wiring you'd want the part # C56296 and you'd be set. |

Location of Factory Connection Point for Trailer Wiring Harness on a 2003 Chevy Venture

Trying to install your c55355 for 2003 Chevrolet Venture Van. I cant find the trailer wiring harness plug. Ive looked at the cable bundle behind the panel and simply cant find the plug. I note that you have a video for 2002 and 2004 but not...

Is There a Difference Between Brake Assembly Part # AKFBBRK-35-D, AKFBBRK-35R-D and # AKFBBRK-35L-D

Can you explain the differences between? AKFBBRK-35-D AKFBBRK-35R-D AKFBBRK-35L-D They appear to be all the same assemble just separate or in the pair, am I correct? | You are correct. We sell the assemblies as a pair as part # AKFBBRK-35-D...

How to Identify Replacement Bearings, Races and Seals for Harbor Freight Trailer 92174

Recommendation for a Harbor Freight Trailer 92174 replacement bearings/seal? | The best way to determine the replacement bearing, race and seal parts needed for a trailer is to pull one of the hubs and remove them so their part numbers can be...

Trailer Hitch Options for a 2004 Isuzu Rodeo with Spare Tire Mounted Underneath

Can I install a trailer hitch with the spare tire mounted underneath on this model. It is a 2 wheel drive. | Yes, there are trailer hitches available for the 2004 Isuzu Rodeo that have the spare tire mounted underneath the vehicle. I have included...

Where is the Trailer Wiring Connection Location on a 2000 Chevy Venture

I have torn the inside of drivers side trim completely out of my van to find where the plugin is suppose to be.The only thing I can find that even looks like it might work is at the tail light itself.Will you please help me? | On a 2000 Chevy...

Wire Gauge and Circuit Breaker Needed to Wire 12 Volt Accessory Circuit to Trailer Connector

Ive not read the details in the wiring of the black 10 gauge wire that goes to the rv 12 volt battery. Ive read about using 10 gauge wiring and that it should be fused but how muchamps, and what kindslow.fast or reset. Im towing a 2000lb popup...

Hitch and Bike Rack Recommendation for a 2000 Isuzu Rodeo

This rack is recommended by your site for the 2000 Isuzu Rodeo, My vehicle has a small spoiler above the back window and cargo rails on top. The spare tire is mounted below the vehicle. We purchased a new mens Diamondback Edgewood and womans...

Setting Up a 2004 Chevrolet Venture to Tow a 2,500 Pound Camper with Trailer Brakes

I would like to pull an ultra light 16 Camper with this van. I need a class III hitch, but do I need air bags installed? The camper weighs about 2,500 lbs. dry and we plan on pulling it about 500 miles both ways on Michigan roads. We also...

Troubleshooting Rhino-Rack Roof Rack Installation on 2018 Mitsubishi RVR Flush Rails

Ive tried to install the kit of the SX031 legs on my 2018 RVR, but if you look at the pics those legs are not straight on the flush rails so when I have the bars on them then they dont fit anymore... Am I doing something wrong or I got the wrong...

Does Duton-Lainson Hand Winch # DL15103 Require Cable Fastener # DL24361 to Secure the Cable

With the above listed winch, do I also need to get item # DL24361 to secure the cable to the winch, or does this come with it. Thanks | Yes, you would need to get the Cable Fastener, # DL24361, to secure the cable to the winch. The winch will...

Filter Your Search