LED Strip Lights Specs:
Features:
15-3/4" long x 1" wide x 5/8" thick. Low-profile LED strip light produces bright white light for an interior area. Durable polycarbonate housing and lens. Surface mount - hardware not included. 2-Wire design. 18 Diodes.
More Information >LED Strip Lights Specs:
Features:
Add 300 lumens of bright white light in your vehicle, toolbox, kitchen, or shop with this LED light strip. Long-lasting LEDs deliver 30,000 hours of light. Hardwires into a constant power source with included lead and ground wires.
More Information >RV Exterior Lights Specs:
Features:
5-5/8" Diameter round. Weatherproof LED utility light produces bright daylight white light to illuminate an interior or exterior area. Chrome bezel adds a polished look. Surface mount - hardware not included. 2-Wire design. 10 LEDs.
More Information >LED Strip Lights Specs:
Features:
Add 328 raw lumens of bright white light in your vehicle, toolbox, kitchen, or shop with this LED light strip. Long-lasting LEDs deliver 30,000 hours of light. Switch activated and dimmable.
More Information >Videos
for RV Interior Lights
Help Articles
for RV Interior Lights
Expert Answers
for RV Interior Lights
A 16 inch tire will not fit on a 16.5 inch wheel. You would either need to get new 16 inch wheels with the proper bolt pattern to match what the hubs require or to get your existing wheels you would need to go with 16.5 inch tires. You mentioned…
view full answer...National seal 472920 has an inner diameter of 2.25 inches and outer diameter of 3.375. For a replacement, you will want Grease Seal - Double Lip #GS-2250DL or oil seal #10-63.
view full answer...There should be 2 inches minimum between the tires on a dual axle trailer. This will allow the suspension components room to work properly but a little more room is ideal. For instance the Ultra-Fab Chock and Lock Wheel Stabilizers for Tandem-Axle…
view full answer...If you look at the brackets of the TorkLift HiddenPower Under-Vehicle Battery Mount #TLA7727…
view full answer...Lippert Carpet Protectors for RVs with Slide Outs #LC134993 do not permanently install though you could leave them where you place them if you want. A slide-out generally slides on 2 rails below the floor of the slide-out room. That is where the…
view full answer...To tow your trailer that uses an RV style 7-way blade style connector with your semi that has a 7-pin connector, you need to construct an adapter that will also combine the brake signal into the right and left directional signal pins. This can be…
view full answer...The first thing to do is disconnect the trailer from the Liberty. Then using a circuit tester, like part #PTW2993, test each pin of the 4-Way. Clip the alligator clip of the circuit tester to the exposed post, the ground wire. Check each pin with…
view full answer...The Thule UpRide Roof Bike Rack #TH599000 will work perfectly on your existing Thule Square Crossbars. This rack includes mounting hardware that will clamp around square, round, or aero-style crossbars without having to use an integrated T-slot. I…
view full answer...The direct replacement for your Atwood Gc6aa/10E water heater has been discontinued. I recommend the Atwood RV Water Heater Item #DMC74FR which only requires a…
view full answer...On oil bath hubs the seals are different than standard grease seals. The correct replacement for what you have is #91030. Unitized oil seals like this have a part that stays fixed and a part that rotates with the hub for optimum leak protection. I…
view full answer...Due to the fact that carbon fiber bikes have a more sensitive frame, Thule does recommend using the Thule UpRide #TH599000. Bike rack technology has not changed to make the racks less compatible, but carbon fiber bikes have become increasingly…
view full answer...