Will Thule Hull-A-Port Roof Kayak Carrier Fit Yakima Core Bar Roof Rack

Question

Question:

will the hullaport fit Yakima core bars?

asked by: Kevin

0

Expert Reply:

Yes, the Thule Hull-A-Port J-style kayak carrier # TH834 will fit fine on Yakima Core Bar roof rack crossbars. These bars, such as 50-inch set # Y00421, have an aero profile that is fully compatible with the hardware on the Hull-A-Port.

expert reply by: Adam R

0

Answer 1

For your 2018 Honda HR-V to be compatible with the Thule Hullavator Pro Kayak Carrier and Lift Assist with Tie-Downs #TH898, you have to use slightly longer crossbars. The Hullavator requires 4-8 inches overhang to give clearance. In order to give…

view full answer...

Answer 2

The height of the Yakima Rack and Roll Trailer - 66" #Y08106 from the ground to the top of the crossbars is approximately 30".

view full answer...

Answer 3

If you are already planning on needing more space than the 66" Yakima Rack and Roll Trailer #Y08106 can provide then I highly recommend going ahead and getting the 78" Rack and Roll #Y08107 instead. The 78" trailer is a whole foot…

view full answer...

Answer 4

The mounting brackets of the Thule Hull-A-Port part #TH834 are compatible with round crossbars like what Yakima offers. Since round bars don't have edges (obviously) the clamps of this rack would need to be tightened pretty good so that the rack…

view full answer...

Answer 5

I can see how the Yakima Rack and Roll would be harder to see if you have a tall SUV. I recommend to add the safety pole part #Y08114 to the Rack and Roll part #Y08107 which is a yellow pole that clips to the frame of the trailer to help make it more…

view full answer...

Answer 6

A motorcycle shop should have no problem replacing the inner tubes of your Rack and Roll Trailer part #Y08106 with new ones like part #Y8880283. Sounds like you may have went to bicycle shops already. These tire setups are more like motorcycle setups…

view full answer...

Answer 7

The Yakima Rack and Roll Trailer - 66" #Y08106 for space saving will need the tongue removed. With the tongue removed, the trailer is 6 feet long. I've attached a photo of this system with tongue and wheels removed for storage to assist.

view full answer...

Answer 8

I reached out to my contact at Yakima and they confirmed that the Heavy Duty Shocks for Yakima Rack and Roll Trailer #Y08110 will fit on the Yakima Rack and Roll Trailer - 66 inch #Y08106. However the 66 inch trailer is not able to carry more than…

view full answer...

Answer 9

For the Yakima Rack and Roll Trailer part #Y08107 the height from the ground to the top of the inside of the coupler where the ball sits is 22 inches so then from the bottom of the coupler lip to the ground measures 20 inches when the trailer sits…

view full answer...

Answer 10

The 66 inch crossbars on the Yakima Rack and Roll Trailer #Y08106 will work great for you. It sounds like the canoes will take up almost all of the crossbars, with their widest points equaling 64-1/2 inches, but will not over-hang the bars. With the…

view full answer...

Answer 11

We actually made a video that covers the assembly of Yakima Rack and Roll trailer part #Y08106 you mentioned that you can use as a guide. Check out the attached link to this page.

view full answer...

Answer 12

I reached out to my contact at Yakima and she said that the compressed length of the Replacement Standard Shocks #8880177 is 9.45 inches. These are designed to replace the standard shocks on the Yakima Rack and Roll Trailer #Y08106 and #Y08107.

view full answer...

Will Thule Hull-A-Port Roof Kayak Carrier Fit Yakima Core Bar Roof Rack

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching