Is Any Welding Required to Install Lippert Ground Control System
Updated 01/30/2017 | Published 01/29/2017
Question:
One expert says the front landing gear for the LC358590 is bolt on using the existing brackets. Another expert says they must be bolted on. Which is it?
asked by: John R
0
Expert Reply:
The front jacks of the Ground Control system # LC358590 will use the existing brackets that the old landing gear used. The only welding that would need to done would be if the brackets on the trailer had to be moved for any reason. I have included a link to the installation instructions for you.
expert reply by:
Michael H
0
Product Page this Question was Asked From
Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Touchpad - 4-Point Set
- Camper Jacks
- 5th Wheel Camper
- Stabilizer Jacks
- Steel
- 10001 lbs or More
- Electric Jack
- 36 Inch Lift
- Bolt-On
- 4 Jacks
- Lippert
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Will the MORryde Short Safe-T-Rail Telescoping RV Hand Rail Work on a 2014 Keystone Avalanche?
- Q&A: Best Auto Leveling System for 2014 Keystone Avalanche 5th Wheel Trailer
- Q&A: Troubleshooting External Sensor Error on Lippert Level Up
- Q&A: How Much Room on RV Frame Does Lippert Ground Control Middle and Rear Jacks Take Up
- Q&A: Can A 30 Amp Surge Protector Be Used On A 50 Amp Travel Trailer?
- Q&A: How to Determine if Lippert Ground Control 3.0 Will Fit 5th Wheel RV
- Q&A: Solutions To Add More Clearance For Lippert Ground Control 3.0 Jack Legs
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Trailer Wiring Diagrams
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: 5 Things to Know About Weight Distribution Hitches