Do I Need Load Resistors To Stop The Hyperflashing When Adding Optronics LED Trailer Light ?
Updated 11/17/2026 | Published 11/16/2026 >
Products Featured in This Question
Question:
I installed these on my bike rack, then wired them in parallel with the existing trailer stop turn signals. I am getting rapid turn signal flashing. Do I need to add load resistors? If so which ones?
asked by: Roy N
Expert Reply:
Good afternoon Roy!
You likely don't need load resistors. Since you added the Optronics # STL79RB lights in parallel with your existing lighting rather than replacing any bulbs, you've actually increased the electrical load slightly. Hyperflashing typically happens when there's too little load, so adding LEDs shouldn't normally cause it.
If resistors are needed, we have the Load Resistor Kit # DI34ZR, which connects between the stop/turn signal wire and ground on each side.
Before going that route, I'd recommend checking your ground connections and wiring splices. You can also temporarily disconnect the new lights to see if the flashing returns to normal.
What's the year, make, and model of your vehicle, and did you connect these lights to an existing trailer's wiring or directly to your vehicle's trailer wiring harness? Also, is the rapid flashing happening on your dashboard or just at the added lights?
That'll help determine whether the issue is related to the vehicle's wiring converter, lighting system, or something else!
Product Page this Question was Asked From
Optronics Streamline LED Trailer Tail Light - Submersible - 3 Function - 11 Diodes - Red Lens
- Trailer Lights
- Tail Lights
- Brake/Tail/Turn
- Oval
- Surface Mount
- Submersible Lights
- LED Light
- 17L x 1-1/2W Inch
- Red
- Optronics
more information >
Continue Researching
- Q&A: Where Does The VELIT Portable Diesel Heater Get Fuel? Is There An Internal Gas Tank?
- Q&A: Is the TecNiq Seven Function Box Style Tail Light TN62XR a Replacement for a Wesbar 271594?
- Q&A: How Much of a Slipper Spring Should be Sticking Out Past the Rear Hanger
- Q&A: Cross Reference a Replacement for a TCM 21334 TB Grease Seal
- Q&A: Replacement for Atwood Heavy Duty MPD 86065
- Q&A: How is Horse Trailer Side Pad # HTP60BK Usually Attached
- Article: Trailer Lighting Requirements
- Q&A: What Is The Smallest Available Spindle Nut For 2.5k Axle?
- Article: Trailer Wiring Diagrams
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Is It Illegal to Leave My Hitch on My Truck?
- Article: How to Measure for Trailer Hitch Drop
- Article: How to Choose the Right Trailer Hitch Class
- Article: Brake Controller Installation: Starting from Scratch


Chuck F.
11/17/2026
I’m afraid I won’t be much help. I lost one tail light on my horse trailer and these were close as I could find as a replacement. During my replacing the tail light and trouble shooting, I discovered the trailer ground to the tow vehicle had been compromised. I repaired the ground and the original light worked as design. So, the new light was not installed. I have installed the light on another car and it works flawlessly but it does not have to flash. I race sport cars and we have to have a rain light. On production based cars, the factory running lights suffice but I bought a new car and when loading the car on the trailer for a race, I discovered the factory lights were not working and I had little or no time to trouble shoot them. I tossed the trailer light and some wire in the car to install it at the track. I used the circuit for the cool suit for power for the light. A little Rube Goldberg-ish but it works and satisfied the tech inspectors.