bing tracking image
Q & A Icon

Does etrailer Base Plate Kit for 2026 Ford Maverick Allow for Better Fit with Adaptive Cruise Contro  

Published 11/16/2026

Question:

I have a 2026 Maverick Lariat. Is this new invisible base plate a better fit for the ACC that is in the middle of the area behind the facia? I see that it has a bridge sort of thing in the middle. Is that to avoid the ACC? The installation video is done on a Maverick that does not have the ACC box. Ideally, they would make one that does not require the removal of any of the shutter vanes. Any chance that can happen? Thanks! e96GV

0

Expert Reply:

Hey Jack, the etrailer Invisible Base Plate Kit # e96GV is one of the better options for minimizing modifications to your 2026 Ford Maverick Lariat. However, there are two important things to know about the adaptive cruise control (ACC) sensor and the active grille shutters that you asked about.

1. Does the raised center section clear the ACC sensor?

The bridge-shaped center section is designed to accommodate components in the center of the vehicle, but unfortunately, it doesn't guarantee clearance around the ACC radar.

According to our fitment information, installing the # e96GV on Mavericks equipped with adaptive cruise control may still require relocating the ACC sensor or its mounting bracket.

If relocation is necessary, a special bracket may be needed, and the ACC system will require recalibration afterward.

2. Can it be installed without removing any grille shutters?

Unfortunately, no. The current installation instructions require removing the second, third, and fourth shutter blades on each side of the lower active shutter assembly.

The good news is that this is less extensive than the modifications required by some competing base plates.

Do you have the rest of your flat towing setup picked out already?

expert reply by:
0
Jameson C
Jack W. profile picture

Jack W.

11/16/2026

Yes all done except this base plate. I sent back my Roadmaster base plate for being TOO intrusive. I'm waiting for someone to make one that does not involve the ACC at all. Makes no sense that they can't make it to fit the car. Rather than relocating and recalibrating the ACC. It should just fit. I have come to terms with a few vanes, but I'm not going to give up the factory ACC. Just not understanding if you can make the metal in Any shape, why not make it in the correct shape in the first place.

Jameson C. profile picture
Etrailer Expert

Jameson C.

11/16/2026

@JackW That's a valid concern. I don't have the ability to look up why they engineered the base plate like that but I do know that if they could have found a way to fit it around the ACC they would have as they incentive is to make the installs as least invasive as they can.

Product Page this Question was Asked From


Q & A Icon

Continue Researching

See More Q&A Expert Answers >>