Recommend Trailer Hitch for a 1972 GMC C/K Series Truck
Updated 09/30/2026 | Published 09/26/2026 >
Products Featured in This Question
Question:
1972 gmc ck series hitch. 8 ft bed . Whats best fit for this truck ? Thanks
asked by: James W
Expert Reply:
Thanks for the information James! I've got two hitches that fit your 1972 GMC C/K Series truck with an 8' long bed. Which one you need is going to depend on what bumper you have. I have listed the options below:
Standard Bumper - Curt Hitch item # C14082
Deep Drop Bumper - Curt 3-Piece Hitch item # C15511
Both of these hitches are custom fit and have a 2" hitch receiver. They include all hardware necessary to complete the installation as well.
What do you plan on towing with your new hitch? Feel free to answer this and throw in any other questions you have, where it says Add Comment.
Product Page this Question was Asked From
Curt 3-Piece Trailer Hitch Receiver - Multi Fit - Class V - 2"
- Trailer Hitch
- For Towing
- Class V
- 1500 lbs TW
- 15000 lbs GTW
- 16000 lbs WD GTW
- 2 Inch Hitch
- 1600 lbs WD TW
- Visible Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Measurement of Curt 3-Piece Trailer Hitch C15511 from End of Mounting Flange to Receiver Tube
- Q&A: Will the Curt Hitch 13028 Fit a 1966 Chevrolet C10 with Aftermarket Bumper
- Q&A: Curt Trailer Hitch Receiver Part # 13028 Dimensions
- Q&A: Dimensions of Hitches for a 1997 Chevy C/K 3500 Cab and Chassis
- Q&A: Side Plate and Bolt Hole Spacing Measurements for Curt Trailer Hitch # C14082
- Q&A: Trailer Hitch Receiver for 1983 Ford F350 with Utility Bed
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Q&A: Recommended Trailer Hitch Receiver For Deep Drop Bumper On 1990 Ford F250 XLT Lariat
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Trailer Wiring Diagrams
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Choose the Right Trailer Hitch Class
- Article: My Trailer Hitch Doesn't Fit
- Article: How to Measure for Trailer Hitch Drop




Ron
9/28/2026
I bought the 15000 lb 3 piece for my 1986 k5 blazer. I had to drill 2 fresh holes and I cleaned up 2 of the others. Nowhere had a serious hitch for the k5. Most of us use truck springs in the back anyhow because of the infamous blazer lean back so it gives an extra leaf to even the blazer out. Figured why not use it for pulling stuff too. Etrailer sells some good products and once I took the measurements this one fit how I wanted to. Like I said.....if you own a k5 you don't have to settle.... a drill and a bit and it's done. Have a helper too because this isn't some scrawny junk