Front Hitch for 1993 Winnebago Itasca Sunrise
Updated 10/05/2026 | Published 09/24/2026
Question:
Hi! Im looking for a front hitch for a 1993 Winnebago Itasca Sunrise 23ft. 300-500 weight. Thanks!
asked by: Claude C
Expert Reply:
Hey Claude!
Our manufacturing partners don't carry a front hitch specifically for the 1993 Itasca Sunrise, so instead you will need to have something fabricated to fit your motorhome. I'd recommend grabbing a Gen-Y Weld-On 2" Receiver Tube # 325-GH-003, taking it and your motorhome to a welder or fabricator, and you'll be good to go! The weight capacity of the hitch will be dependent on the weld quality, but I doubt you'll have any issue with weight, as they're typically rated higher than the motorhome is rated to carry. Just check with your owner's manual to confirm your target weight is okay!
What do you plan on carrying with the front hitch?
Claude C.
10/2/2026
Jerry, It's been a bit of a monsoon season over here -- so there's been no progress yet. I bought a front hitch from you folks back in 2025-- for my RoadTrek RV -- works great. I'll probably have to have something custom made for the Itasca. I'll keep you in the loop. Couldn't really find anything on Winnebago forums... Thanks, Claude Curran
Jerry B.
10/5/2026
Product Page this Question was Asked From
Gen-Y Weld-On 2" Receiver Tube - 12" Long - Steel
- Hitch Fabrication Parts
- Receiver Tube
- 12 Inch Long
- Raw Finish
- Fits 2 Inch Hitch
- 7/16 Inch Thick
- Gen-Y Hitch
more information >
Continue Researching
- Q&A: Can't Find Replacement for Older Dexter 22834 Hub
- Q&A: What Is The Difference Between the 6K and 7K Dexter Axle Electric Brake Assemblies
- Q&A: Dimensions of the Gen-Y Weld-On 2 Inch Receiver Tube
- Q&A: Lock N Roll Hitch Assembly for 5 Inch Drop
- Q&A: Trailer Mounted Step That Can Be Installed on Trailer Tongue Near Tool Box
- Q&A: Jack Recommendation for a Trailer Frame with 2 inch by 2 inch Channel Dimensions
- Q&A: What Is The Thickness Of The Buyers 2 I.D x 10 Long Receiver Tube
- Article: Top Weight Distribution Hitches for a Buttery Smooth Ride
- Article: Which Hitches are Made in the USA
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Article: How Level Should a Tow Bar Be When Flat Towing
- Article: My Trailer Hitch Doesn't Fit
- Article: Best Hitch Cargo Carriers
- Article: Hitch Mounted Cargo Carrier Information
Gary
9/27/2026
The 12 inch receiver tube would be great to fabricate a front hitch. It is made of quality steel and be able handle it. Just get a good weld. It comes predrilled and ready to go.