What is the Center Hole Size for the Yates Boat Trailer Roller # YR12243-5
Updated 07/23/2014 | Published 07/21/2014 >
Question:
Can you provide the exact hole size to 3 decjmal places?
asked by: Brian
0
Expert Reply:
The hole size on the Yates boat roller # YR12243-5 would be 0.705 to 0.710 inches based on the few I measured using digital calipers. However, there is always the chance of slight variations, tolerances, for each one of these rollers since rubber can move and flex.
expert reply by:
Michael H
0
Product Page this Question was Asked From
Yates Side Guide Roller for Boat Trailers - Heavy-Duty Rubber - 12" Long - 5/8" Shaft
- Boat Trailer Parts
- Rollers
- Side Guide Roller
- 2-1/2 Inch Diameter
- Rubber
- 12 Inch Long
- Fits 5/8 Inch Shaft
- Yates Rubber
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: How Much Roller Shaft Length will Yates Endcap for Side Guide Rollers # YR224-4 End Up Taking up
- Q&A: Replacement 6" x 2" Roller for Older Boat Trailer
- Q&A: Can the Yates Side Guide Roller # YR12243-5 be Cut for a Specific Length
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Q&A: Replacement Rollers For 1965 Vintage Boat Trailer
- Q&A: How to Pick Out Trailer Hubs for Older Dilly Trailer
- Q&A: Will Malone AirFlow2 Roof Rack Fit 2017 Toyota RAV4 With Raised Rails & Hold Rooftop Tent
- Q&A: Roof Rack For Carrying Two Tooenjoy Lift Assist Racks On A 2015 Toyota 4Runner
- Article: Boat Trailer Guides: Which are the Best?
- Article: How to Change the Axle on your Boat Trailer Without Leaving your Driveway
- Article: How to Measure a Boat Trailer Axle
- Article: Trailer Lighting Requirements
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision


