What Is The Mounting Hole Spacing For The Hook and Keeper 37210444B
Updated 04/27/2026 | Published 04/24/2026
Products Featured in This Question
Question:
What is the distance in between the mounting holes?
asked by: Bruce L
0
Expert Reply:
Hey, Bruce. That's a really great question.
The distance between the mounting holes on the JR Products Hook and Keeper # 37210444B is 1" side to side and 2-3/16" from top to bottom. This is pretty standard hole spacing, so if you’re replacing an older hook and keeper, it will most likely line up with your existing holes.
What camper are you planning to mount this on?
expert reply by:
Gwendolyn Y
0
Dimensions
(click to enlarge)
(click to enlarge)
Product Page this Question was Asked From
Hook and Keeper for Enclosed Trailer - 6" Hook - Polar White
- Trailer Door Holders
- Hook and Keeper
- Straight
- 6 Inch Long
- Plastic
- JR Products
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Shop: Bottom Rail Trim for Trailers - 93-1/2" Long x 1/2" Tall x 2-3/4" Wide
- Shop: Uneven Rub Rail Trim for Enclosed Trailer - 1-1/2" Tall x 5/16" Deep - Aluminum
- Q&A: Fork Mounted Roof Bike Rack that Can Carry Trek Verve 3
- Article: Trailer Wiring Diagrams
- Q&A: Closest Replacement RV Door Latch For A 2000 Coachman Catalina Lite
- Q&A: Recommended Trailer Hitch Receiver for 2007 Kenworth T300
- Q&A: Correct Replacement for Power Gear Above Floor Slide Out Motor 368807
- Q&A: Replacement A-Frame Jack for a Forest River Pop-Up Camper
- Q&A: Compatible Replacements For A Lippert Rhino Box Pin Box On A 2021 Cedar Creek 37MBH
- Q&A: How to Correctly Measure for Trailer Steps
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: Is It Illegal to Leave My Hitch on My Truck?
- Article: Troubleshooting Brake Controller Installations
- Article: Brake Controller Installation: Starting from Scratch