Replacement LED Submersible Light Kit, Bar Light and Clearance Lights for a Boat Trailer
Published 07/10/2014 >
Products Featured in This Question
Question:
I have a 1991 Shorelander boat trail with the bar light and 6inch rectangular lights. The rear tie down straps for the boat are part of the frame which is adjacent to the rear lights on the inside. I noticed your lights, however you do not show any kits for the led light conversion with a center bar light. Your conversion kit also does not include the two red and yellow lights mounted front and rear on the fenders. Any assistance with these two nuances would be appreciated?
asked by: John J
Helpful Expert Reply:
Product Page this Question was Asked From
LED Combination Tail Light Kit for Trailers under 80" Wide - Submersible - Driver and Passenger
- Trailer Lights
- Tail Lights
- Brake/Tail/Turn
- License Plate
- Marker
- Rectangle
- Surface Mount
- Submersible Lights
- LED Light
- 6L x 3-1/2W Inch
- Red
- Optronics
more information >
Continue Researching
- Article: Trailer Lighting Requirements
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Trailer Wiring Diagrams
- Q&A: What is the Difference Between Over 80 inch and Under 80 inch Trailer Tail Lights
- Q&A: Is The etrailer e89FV Have The Same Specs as the Dexter 072-079-00 Spring
- Q&A: Where to Connect Curt Wiring 12V Hot Lead In 2026 Kia Sportage Hybrid
- Q&A: Is There A Lift Kit Option for A Dexter Torflex #13 Axle
- Q&A: Passenger Side Light That Matches The Driver Side Optronics LED Tail Light STL37RPG
- Article: Trailer Tire Sizing
- Article: Most Popular Wheel Bearings
- Q&A: Replacement Oil Bath Cap for AL/KO 10 K Axle w/ 3-3/4 Inch O.D.
- Q&A: Will Optronics Submersible LED Trailer Tail Light # STL56RB Fit a 1987 Shorelander Trailer
- Article: My Trailer Hitch Doesn't Fit
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)

