Why Does the Charge Light Stay on the Trailer Breakaway Kit 3802336 After the 7-Way is Disconnected?
Updated 03/09/2026 | Published 03/04/2026 >
Products Featured in This Question
Question:
Why does the charge indicator led stay on even after the trailer is unplugged from the tow vehicle. The kit is new and the battery is at 13.04. Thanks
asked by: Shane
Expert Reply:
Hey Shane. The light on the Bright Way Trailer Breakaway Kit item # 3802336 staying on after you unplug the 7-way means it's still drawing power. Most likely from your trailer's battery. If it's connected to a solar setup it'll draw power from there too.
Is your Bright Way Trailer Breakaway Kit item # 3802336 connected to your trailer's battery?
You can add this information, along with any other questions you have, where it says Add Comment.
Product Page this Question was Asked From
Bright Way Trailer Breakaway Kit with Switch and 0.5-Amp Charger
- Trailer Breakaway Kit
- Kit with Charger
- Side Load
- Top Load
- Single-Axle
- Tandem-Axle
- Tester Not Included
- Electric
- Battery Not Included
- 48 Inch Long
- Bright Way
more information >
Continue Researching
- Article: Trailer Wiring Diagrams
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Q&A: 2-1/2" Hitch Receiver Extension that Reduces to 2" Receiver
- Article: Trailer Lighting Requirements
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Wiper Blade Recommendation For 2027 Kia Telluride EX Hybrid
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Wiring Diagrams for Installing Bright Way Trailer Breakaway ICU Kit # BW94FR
- Q&A: Parts Needed to Add Brakes to Ranger Boat Trailer
- Q&A: Looking For Brakes And Hubs For 10K American Axles
- Q&A: Replacement Front Mounted Trailer Jack For Cattle Trailer
- Q&A: What Gauge Wire Should be Used to Wire Trailer Brakes
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Article: Brake Controller Installation: Starting from Scratch



Shane
3/8/2026
Its on a car hauler trailer with no AUX batteries at all. I'm getting power feedback up to my plug when its disconnected. I'm guessing there is no diode to keep this from happening. Is the built in charger shot? Without a diode that poor little battery is getting full amperage from the vehicle alternator. Not the .5-1 amp that it should be getting.