Recommended Portable Solar Panels for a Nobo 18.2 w/ GoPower Solar

Question

Question:

I have a 2025 Nobo 18.2 with GoPower solar on the side that is rated for 20amps. Do you have a portable solar kit that would work with this?

asked by: Scott M

0

Expert Reply:

We sure do Scott. We've actually got a couple of options depending on how many watts of solar power you're interested in adding and whether or not you've already got a solar controller. I've listed our options below:

110 Watt Solar Panel - Go Power Solar Flex Charging System with Digital Solar Controller - item # 34272629

190 Watt Solar Panel - Go Power Solar Flex Eclipse Charging System w/ MPPT Solar Controller item # GP67MR

If your Nobo already has a solar controller you can plug the 110 Watt Solar Panel item # 34272629 directly into your setup with the included connectors.

What kind of devices or appliances are you wanting to power off of solar?

You can add this information, along with any other questions you have, where it says Add Comment.

expert reply by: Jerred H

0

34272629
(click to enlarge)

Scott M.

1/28/2026

I was looking for something more like the GoPower GP-PWM-30-SB. I have 200ah of Lithium batteries and I'm looking for a self contained option with 200 watts or more (under the 20amp rating) with an SAE plug (which I think is what Nobo uses right?)

Jerred H.

1/29/2026

@ScottM If you're interested in the Go Power PWM Solar Charge Controller with Bluetooth item # GP76QR you can get the Go Power Solar Flex Charging System with Digital Solar Controller item # 34272630 that includes the item # GP76QR along with a 100 watt portable panel. Adding the Go Power Solar Flex Expansion Kit item # 34272629 would get you up to 210 watts of solar. The 10AWG Solar Connector to SAE Adapter item # RS39VR is what you'll need to connect everything to your 2025 Nobo 18.2.

Answer 1

Hi Michael! We do indeed have a RAS kit that will fit your 2024 Nissan Titan SV. Actually a couple of them and just to make sure, I double checked with RAS and they said these options will fit if you have the XD or SV, so you are definitely good to…

view full answer...

Answer 2

I checked with Lippert and the part number you have of 1510000140 corresponds with the Revolution Kwikee step and the replacement control module you need then is the part #LC363985.

view full answer...

Answer 3

The brake controller install connector on your 2019 Nissan Titan is supposed to be under the dash above the gas pedal. If you check out the install video link I attached on this page at the 3:10 mark our installer shows where to find the connector on…

view full answer...

Answer 4

Can you email me the diagram so I can take a look at it?

view full answer...

Answer 5

Hey Kevin, Thanks for your question. We actually don't carry any Load Range E trailer tires in the ST205/75R14 size. The highest load rating we offer in that size is Load Range D, which provides a capacity of 2,200 lbs per tire. Based on the…

view full answer...

Answer 6

No, when adding additional panels like the Go Power Solar Flex Eclipse Expansion Kit #GP77MR in parallel, you do not need a fuse for each panel. Since the panels are connected in parallel and then go through the charge controller before reaching the…

view full answer...

Answer 7

Hi Mark; have you tried looking behind the center dash storage pocket? Technically on the vehicle the location is BH7. It will be similar to the attached picture on an Expedition. You can also take a look at the installation video I attached further…

view full answer...

Answer 8

Hey Stuart, I checked the part number you found on your steps and it came back as a 2-step MORryde StepAbove RV step Gen 2 which is what the part #MR66RV you referenced is designed to fit. If you need the hinge pin too you'd want the part…

view full answer...

Answer 9

Hi Mike, If you're going to be running your 12V fridge, cooling fans, and display off your dual AGM batteries; you can use the Go Power Solar Flex Eclipse Charging System part #GP67MR with the addition of another panel. The Go Power Solar Flex…

view full answer...

Answer 10

Hey Robert, glad to hear the project is coming together! Great question on the etrailer PWM Solar Charge Controller #e42PR , those “Solar Appliance” aka 12V appliance terminals are essentially a load output from the controller. They’re designed to…

view full answer...

Recommended Portable Solar Panels for a Nobo 18.2 w/ GoPower Solar

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching