Hubs and Brakes for etrailer 5,200 lb Trailer Axle Beam with Easy Grease Spindles
Updated 01/27/2026 | Published 01/06/2026
Products Featured in This Question
Question:
I'm also ordering your E45GR axle , will this system work on this axle?? the parts that you recommend I would need 4 of the ez-lube hubs and 2 break assemblies?
asked by: marvin
Expert Reply:
Hey Marvin! The Easy Grease Trailer Hub and Drum Assembly # AKHD-655-6-G-EZ-K and etrailer Electric Trailer Brakes # AKEBRK-7-SA will fit the Trailer Axle # e45GR. If you need two axles then yes, you will need four of the hub and drum assembly and two sets of the brake assemblies.
You will also need a U-Bolt Kit # APUBR-8 to mount the axle if you don't already have those parts.
Are you replacing old axles or are you building a trailer?
(click to enlarge)
Product Page this Question was Asked From
Trailer Axle Beam with Easy Grease Spindles - 86-1/2" Long - 5,200 lbs
- Trailer Axles
- Leaf Spring Suspension
- Standard Grade
- No Hubs
- 5200 lbs
- Spindles Only
- 71-1/2 Inch Spring Center
- 86-1/2 Inch Hub Face
- No Drop or Lift
- etrailer
more information >
Continue Researching
- Q&A: Does the Band Around the Spring Pack Go Forward When Installing Leaf Springs?
- Q&A: Replacement Axle for a 84-1/2" Hub Face
- Q&A: Need Replacement Axle for LCI 4400 LB axle that says 95.5/75
- Q&A: Can the Spindle Ends Be Replaced on an LCI52-SB-86.5-68.5 Axle
- Q&A: Replacement Axle Beam for 2020 Grand Design Reflection 315RLTS
- Q&A: What Are The Bolts Pointing Towards Hub On The etrailer Trailer Axle Beam # e33GR
- Q&A: Correct Bearings and Grease Seals for Dexter Axle # 8437302 on Keystone Cougar
- Article: How to Measure a Trailer Axle
- Article: Trailer Wiring Diagrams
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: Most Popular Wheel Bearings
- Article: Double-Eye Trailer Suspension System Review
- Article: How to Measure Your Trailer Wheel Bolt Pattern
Robin H.
1/27/2026
Hey Marvin, how did everything go fitting the hubs and brake assemblies on your E45GR axle? Your update could make it easier for the next person working on a similar trailer setup.