Dimensions of the Square Corner T-Strap Hinge PLR2208R

Question

Question:

I am trying to match up the hinges on my SnoPro snowmobile trailer. I believe they are the Polar 3208. Do you have these or something comparable? Thanks

asked by: Dan L

0

Expert Reply:

Hey Dan. I do not have a database that shows me what parts are on your SnoPro trailer but I can give you the dimensions of the Square Corner T-Strap Hinge w/ Reverse Bracket item # PLR2208R you were looking at so you can compare it to yours.

The Square Corner T-Strap Hinge item # PLR2208R measures 8" long x 2" wide. The bracket is 4-1/2" tall. The distance between the mounting holes from center to center are 3-5/16" on the strap and 3-1/4" on the bracket. The pin diameter is 1/2".

What are the dimensions of your current hinges and do you see any part numbers on them?

You can add this information and any other questions you have where it says Reply to Jerred H and I'll be happy to answer them.

expert reply by: Jerred H

0

Square Corner T-Strap Hinge
(click to enlarge)

Dan L.

11/20/2025

I got the PLR3408 and they matched up perfectly! Thanks

Jerred H.

11/21/2025

@DanL You're welcome! That's great to hear. Let me know if you have any questions down the road!

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 5

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 6

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 7

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 8

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 9

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 10

The Demco Hydraulic Trailer Brake Actuator part #DM72VR should be a direct replacement for the Atwood 61101 Brake Actuator that you have now. This newest updated it rated at 7K instead of 6K. This is a bolt on option that mounts on 3" centers.…

view full answer...

Answer 11

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 12

You can use leaf springs that are rated higher than the axle without any issues as long as they measure the correct measurement for your trailer. For example the 6-leaf double eye spring for 7,000 lb axles part #e64SR measures 24-7/8" eye to…

view full answer...

Dimensions of the Square Corner T-Strap Hinge PLR2208R

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching