Will Rubber Window Edge Weather Strip Fit 2023 Grand Design Imagine XLS 17MKE
Updated 12/01/2025 | Published 11/07/2025
Question:
Will this fit windows on a 2023 Grandesign XLS17 ??? You can see where the rubber is bubbled out. I’m afraid that water can get in. I have 2dide windows on my slide out like that. Thanks for any help
asked by: Robert B
(click to enlarge)
Expert Reply:
Hello Robert; more than likely the Rubber Window Edge Weather Strip # SR66ZR will fit your 2023 Grand Design Imagine 17MKE XLS. However, without being able to see the side profile I can't say for sure.
Grand Design doesn't list the weatherstrip on their parts site either so I have no way to check. I would pull it out and compare it to the picture below to make sure it matches. You will be able to press it back in after you check until you can get a new seal installed.
(click to enlarge)
Product Page this Question was Asked From
Rubber Window Edge Weather Strip for RVs - Press In - 12' Long x 1/2" Tall
- RV Window Parts
- Weatherstrip
- Windows
- Rubber
- 12 Feet Long
- 1/2 Inch
- Black
- Steele Rubber
more information >
Continue Researching
- Q&A: Can GE Appliances Deluxe RV AC Be Used With Thermostat From Existing Setup
- Q&A: Recommended Replacement Window Edge Weather-Stripping and Installation
- Q&A: Looking For Parts For A Schwintek Slideout System
- Q&A: Recommended TorkLift Tie-Downs for a 2023 Ford F-250 w/ a 6-1/2' Bed
- Q&A: Custom Tiedowns for a 2025 Ford F-350 Super Duty
- Q&A: Is The Price On The Americana Trailer Wheel Center Cap AM90154 For 1 Cap?
- Q&A: Replacement Window Seals For A CrossRoads Zinger Travel Trailer
- Article: Most Popular Wheel Bearings
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide
- Article: Trailer Lighting Requirements
- Article: Dielectric Grease Review
- Article: Rooftop Cargo Carriers
Robin H.
12/1/2025
Hey Robert, what did you find when you compared your window seal to the weather strip profile? Once you checked it, were you able to press it back in and keep water out? Your update could make it easier for others with the same Grand Design setup.