Recommended Hitch for a 1995 E-350 Transit Bus w/a 42" Wide Frame
Updated 12/01/2025 | Published 10/28/2025
Products Featured in This Question
Question:
What is the width from center of mounting hole on one fram rail to center of mounting hole on opposite fram rail? I have an extended 1995 E350 suoer Duty. Its a transit bus and the width outside to outside of fram rail is a little over 42inch I will need to drill holes as it is just flat channel.
asked by: Jake
Expert Reply:
Hey Jake, thanks for the measurement. The Curt Hitch item # 14053 fits the 1995 Ford E-350's that have bolt holes spaced 38-5/8" from the center to center of your frame. I checked with our vendors and there's no custom fit hitches for your transit bus. In order to add a hitch to it, you will need a universal weld-on hitch.
There are three different options, with each of them being Class V hitches with a 2" receiver. They fit frames that are between 18" and 44" wide, so they will fit your 1995 E-350's 42" wide frame. The difference between them is the amount of drop they give from the frame, so you'll want to measure the amount of drop you need to clear the bottom of your rear bumper. I have listed them below:
3" Drop: Class 5 Universal Weld-on Hitch and Brackets item # 15901
9" Drop: Class 5 Universal Weld-on Hitch and Brackets item # C47CR
18" Drop: Class 5 Universal Weld-on Hitch and Brackets item # C99CR
How far below your frame is the bottom edge of your bumper?
(click to enlarge)
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class IV - 2"
- Trailer Hitch
- For Towing
- Class IV
- 1000 lbs TW
- 10000 lbs GTW
- 12000 lbs WD GTW
- 2 Inch Hitch
- 1200 lbs WD TW
- Visible Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: What Are the Mounting Hole Dimensions for Curt Trailer Hitch Receiver 14053
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: What Is The Width Of A Trailer Hitch Receiver For My 1998 Ford Expedition?
- Q&A: Which Trailer Hitches Will fit a 2002 Ford E150 Econoline Van
- Q&A: Trailer Hitch Receiver Compatibility For a 1997 Ford Econoline E-250 Van
- Q&A: Recommended Trailer Hitch Receiver For 1994 Ford E350
- Article: Trailer Wiring Diagrams
- Article: Brake Controller Installation: Starting from Scratch
- Q&A: Location of Brake Controller Install Connector on 1994 Ford F250
- Q&A: Difference Between Curt Hitch # 14053 and # 14055
- Article: Trailer Hitch Receiver Sizes
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Stability Control for Heavy Duty Vehicles
- Article: How to Measure for Trailer Hitch Drop
Jerred H.
12/1/2025
Hey Jake, were you able to measure how far the bottom of your bumper sits below the frame on your E-350? Knowing that drop would help confirm which of the universal weld-on hitches fits best. Your update could make it easier for others working on similar transit bus setups.