Replacement Bearings and Grease Seal for Overland Trailer
Updated 10/22/2025 | Published 10/19/2025
Products Featured in This Question
Question:
Hi, I have an odd sized small overland trailer Im trying to replace the bearings on. I assume the canadian fabricatorinch brings the trailers in from overseas direct. On it were: WLFinch Brand -L68149 w/ L68110 -12749 w/ LM12710 -unknown seal number My major question: My seal shaft diameter measures 1.4835. Its not worn or grooved. Does a L68110/2.32inch OD and 1.48inch ID seal even exist?
asked by: Andrew
(click to enlarge)
Expert Reply:
Hi Andrew; the # L68149 and # L68110 are something we carry. The LM12749 and corresponding race are no longer around so you would have to source those elsewhere. The only seal that comes close, and what I think it must be, is the # TMK89ZR. This has an ID of 1.500" and OD of 2.332" so it is the closest possible match.
(click to enlarge)
Product Page this Question was Asked From
- Trailer Bearings Races Seals Caps
- Races
- Standard Races
- 2.33 Inch O.D.
- Bearing L68149
- Race L68110
- 3500 lbs Axle
- etrailer
more information >
Continue Researching
- Q&A: What Replacement Rotors and Brake Pads do I Need for My Kodiak Disc Brakes K2HR12A11-120DW?
- Article: Most Popular Wheel Bearings
- Q&A: Replacement Hub for a UFP 13674
- Q&A: Correct Replacement for UFP H-1377 Trailer Hub
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Q&A: Can Brake Parts be Replaced on Dexter 2,800 Pound Axles with Weld-On Trailer Brake Assemblies
- Q&A: Heavy Duty Suspension Kit for Replacing Equalizers that are 7-3/4 inches Long
- Q&A: How Do I Know If My 10k AL-KO/Hayes Brake Caliper Is For The Right Or Left Side Of A Trailer
- Q&A: Does Ventline E-Z Lift Ventadome Trailer Roof Vent # V3092-603-00 Have Ceiling Garnish
- Article: How to Bleed Your Trailer Surge Brakes
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
Andrew
10/22/2025
Thank you Robin! My follow up question would be: This seems like the best solution would be to press a machined collar over the seal surface to take it from 1.48 up to a standard size. Or just replace the whole spindle.