Is There a 4-Way Wiring Harness for a 2026 Chevy Equinox Activ?
Updated 10/18/2025 | Published 10/15/2025
Products Featured in This Question
Question:
Looking to see if there is a 4pin connector available yet for a 2026 Chevy Equinox Activ. I have only been able to get the 6pin version which does not work. Thanks!
asked by: Kienan
(click to enlarge)
Expert Reply:
Hey Kienan thanks for the picture.
The only solution I have for you is the Curt Powered Tail Light Converter with 4-Pole Flat Trailer Connector item # C59236. This is a universal wiring harness that uses clamps instead of splicing and cutting wires. It connects directly to the wiring leading to your tail lights and the sensors inside the clamps read the electrical signals being sent through them. The control module then reads the signals and sends them to the 4-Way connector.
I do not have any information on when there will be a plug and play aftermarket 4-way wiring harness for the 2026 Chevy Equinox without the tow package.
What are you needing a wiring harness for?
You can add this information and any other questions you have where it says Reply to Jerred H and I'll be happy to answer them.
Product Page this Question was Asked From
Curt Powered Tail Light Converter with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Vehicle End Connector
- Powered Converter
- Universal Fit
- 4 Flat
- Plug and Lead
- Splice-In
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Search Results: hitch pin and clip
- Shop: Trailer Wiring
- Shop: Trailer Hitch
- Search Results: boat trailer leaf springs
- Search Results: trailer suspension parts
- Search Results: boat trailer parts
- Video: Installing the Curt Trailer Hitch Receiver on a 2026 Chevrolet Equinox
- Search Results: curt trutrack
- Search Results: 17520
- Search Results: stake pocket step
- Shop: Curt Powered Tail Light Converter with 4-Pole Flat Trailer Connector
- Video: Review of OptiMate 12V Power Accessories - Power Socket - MA74BV
- Shop: Curt T-Connector Vehicle Wiring Harness for Factory Tow Package - 4-Pole Flat Trailer Connector
- Shop: Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Shop: Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Q&A: Bearings and Grease Seal for Terran Axle Idler Hub
- Video: Best 2026 Chevrolet Equinox Trailer Hitch Options
- Video: etrailer Class III Trailer Hitch DIY Installation - 2025 Nissan Pathfinder
- Video: Review of Redarc Trailer Brake Controller - Tow Pro Link BT Proportional Brake Controller - RED57AR
- Shop: Brake Controller
- Shop: 3-Leaf Slipper Spring w/ Radius End for 1,500-lb Trailer Axles - 24-5/8" Long
- Shop: RV Designer Socket and Boot - 6 Way
- Shop: etrailer RapidRamps 6' Long Bolt-On Trailer Ramps for over 6-1/2' Wide Trailers
- Video: Curt Powered Tail Light Converter Installation - 2023 Kia Telluride
- Video: Installation of the Roadmaster Battery Disconnect for Towed Vehicles in a 2025 Chevrolet Trax
- Shop: Vehicle Tow Bar Wiring
- Shop: Vehicle Tow Bar Brake System
- Shop: Fifth Wheel Hitch
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Shop: Base Plate for Tow Bar
on Custom Fit Vehicle Wiring
Kienan
10/16/2025
Need the harness so I can tow my trailer (and dirtbike). Tow capacity is only 1500lb so can’t do a whole lot with it but a 500lb trailer and 300lb bike should be fine. Was looking for something that’s direct plug and play so that I don’t have to disassemble everything to wire it. That doesn’t seem to be available anywhere so I guess I’ll have to wait until it becomes available.