What Does Pendent of Progressive Dynamics Charge Wizard Do

Question

Question:

Im trying to understand what the role of the pendent is on my new converter?

asked by: Dwayne H

0

Expert Reply:

Hey Dwayne, the pendent on the Progressive Dynamics panel # PD79RR that you have is designed to provide you with a visual indicator of the converter's battery charging status and allows for manual control over the four charging modes Boost, Normal, Storage, and Desulfation. What type of battery are you charging?

expert reply by: Jameson C

0

Dwayne H.

10/8/2025

a lithium battery

Jameson C.

10/8/2025

@DwayneH oh nice. How do you like it?

Dwayne H.

10/9/2025

@JamesonC I like it. Do you have a suggested setting for the pendant?

Jameson C.

10/9/2025

@DwayneH Most of the time normal setting will be best. On the side of the converter though you will want to press the mode button till it shows the blue color as that is the lithium profile.

Answer 1

Hey Gerald, the Progressive Dynaimcs 9300 converter part #PD49RR is lithium battery compatible so it would work just fine with a 300 amp hour lithium battery. It would take basically 10 hours to completely charge your battery if it was totally dead…

view full answer...

Answer 2

For most RVs greased hubs are a better option than oil bath hubs, and for the exact reason you mention. While it is obviously not good to run your greased hubs without a full load of grease, this tends not to result in catastrophic failures, mostly…

view full answer...

Answer 3

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 4

Since wire color codes are NOT universal, we always recommend wiring by function, rather than wire color. If you look at the Trailer Wiring FAQ article I have linked you to, you can see some diagrams showing the proper way to wire a vehicle and…

view full answer...

Answer 5

Hey Steve, RV AC units are designed to be powered by AC power and not DC like what a battery like what part #RS74VR provides but if you have a power panel in your RV it will have AC power circuits and it will be wired up so that the panel can draw…

view full answer...

Answer 6

Hello Bruce, Thanks for writing in! Using butyl tape between the trailer body and the Single Axle Jeep Style Trailer Fender - Diamond Plate Aluminum - 13" to 15" #HP96VR is exactly the route I would go. It stays flexible, creates an…

view full answer...

Answer 7

Hi Ric; using a converter that is not rated for lithium is not recommended. Your existing WFCO converter won't be able to fully charger a battery like #34282738, it could overheat, and might trip the BMS which would shut the battery down until it…

view full answer...

Answer 8

Hey David, welcome back! The big advantage you'll gain using a 65 amp item #WF98FR or 75 amp item #WF48FR converter charger over a 55 amp item #WF38FR would be to charge your batteries faster. You would also be able to power more 12V DC…

view full answer...

What Does Pendent of Progressive Dynamics Charge Wizard Do

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching