Lifting Stuck Lid of MaxxFan RV Roof Vent to Replace Operator
Updated 09/12/2025 | Published 08/16/2025
Question:
I ORDERED THE MA10-20281K-1AFI AND EXPECT IT IN A FEW DAYS. PROBLEM IS I CANNOT OPEN THE COVER AT ALL AND AM AFRAID OF BREAKING SOMETHING. HOW DO I GET TO THE damage electric lift motor? I do not see this answer in your QandA. Jim. Thanks.
asked by: Jim R
Expert Reply:
Hey Jim, the # MA10-20281K-1AF that you are planning on replacing is what would be preventing your lid from going up if its stuck. So since it's already broken you can go ahead and force the lid up as it's going to get replaced any way. Does the knob turn on the inside at all? You might try having someone crank the knob while you lift on the lid or push it through the bottom and that might allow it to come up a bit easier.
Product Page this Question was Asked From
Replacement Operator Mechanism for MaxxAir MaxxFan Plus or MaxxFan Deluxe Roof Vents
- Accessories and Parts
- RV Vents and Fans
- Roof Vent
- Operator Parts
- MaxxFan Deluxe
- MaxxFan Plus
- Operator
- MAXXAIR
more information >
Continue Researching
- Q&A: What Causes MaxxAir Maxx Fan Lid Not to Open or Close
- Q&A: Replacement Operator Mechanism for MaxxAir MaxxFan 4751KS
- Q&A: Air Force One Air Jumper Kit For Spartan K2 Chassis.
- Q&A: Replacement for a Sharp Carousel Microwave R-820BK-F
- Q&A: Replacement Entry Door Hinge Option For A 2011 Tiffin Allegro Motorhome
- Q&A: Replacement Entry Door Hinge Kit Needed for 2011 Tiffin Allegro Open Road 35QBA
- Q&A: Recommended Replacement For Two Dometic 630035.331 RV AC Units
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Replace or Install an RV Roof Vent
- Article: Fifth Wheel Trailer Hitch Information and Installation Tips
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: Brake Controller Installation: Starting from Scratch
- Article: How to Bleed Your Trailer Surge Brakes
Jameson C.
9/12/2025
Hey Jim, did turning the knob or having someone help lift the lid make it easier to access the motor? I'm asking because your experience could help others facing a similar issue.